LG 14HQ901G-B Owner's Manual page 35

Making connections-Wireless connection
1
The wireless factory default settings are as follows:
•
Station mode (connection via external AP)
- SSID: LGEDXD
•
AP mode (connection via detector AP)
- SSID: LGEDXD_SOFTAP
2
It is possible to change the Wireless Settings using LG DXD Calibration Software.
- Please see "Wireless AP Settings" for details.
3
Press (Wired/Wireless Connection button) for at least one second to switch between the following connection
modes, in respective order: Ethernet/Station/AP mode.
4
The Connection method as below.
• Station mode
- PC settings and connection with Detector are same with wired Connection.
•
AP mode
- Enter [Wi-Fi] under PC Settings, and enter [Show available networks].
- Attempts are made to connect after checking the DXD wireless AP SSID, which is shown as the research
result (the initial value is LGEDXD_SOFTAP). Enter the password to connect.
- If the ping test fails despite the wireless connection being complete, please enter the IP address as follows:
1. Launch the [Network and Sharing Center] and click [Change adapter settings].
- (Control Panel > Network and Internet > Network and Sharing Center > Change adapter settings)
- Select a network adapter.
2. Go to [Properties] in Local Area Connection.
3. Select [Internet Protocol Version 4 (TCP/IPv4)] and then click [Properties] to set the IP address as
follows:
- IP address: 10.10.10.2 ~ 10.10.10.254 (set an IP address other than 10.10.10.99, 10.10.10.100)
- [Subnet Mask]: 255.255.255.0
- [Default Gateway]: 10.10.10.1
- Do not set up DNS.
NOTE
•
Refer to the wireless access point setup guide.
- "Wireless Access Point Setup Guide (Model: Cisco Linksys EA9200)"
35