DEWALT
®
Signal Live Hub - Quick Start Guide
Thank you for choosing DEWALT
Please follow the below instructions and you'll be monitoring your concrete strength in no time.
INTRODUCTION
DEWALT
®
Signal Live is our wire-free system for monitoring concrete strength in realtime. The DEWALT
consists of two elements:
DEWALT® SIGNAL SENSORS
The DEWALT® signal sensor sits in concrete and collects
temperature data, which will be transmitted via Bluetooth
to the DEWALT® Signal Live Hub
SETTING UP
Installing the Hub
1.
Please charge the Hub fully before use;
2. Place the Hub in a central and open location close to
the DEWALT® Signal Sensors. Note that the Hub can
collect data from up to
3. Activate the DEWALT® Signal Live Hub by pressing the
power button. Wait up to 5 minutes until the LED comes
on. It will enter setup mode;
4.
During setup mode view the sensors in range of the
Hub on the site inventory screen on the platform (see
below);
5. For best performance, we recommend fixing the Hub:
●
Up to 5m from
In a location with clear line of sight to the sensors;
●
●
Somewhere with a view of the sky and good cellular
signal strength;
®
as your concrete monitoring solution.
10
sensors;
sensors;
DEWALT® SIGNAL LIVE HUB
The DEWALT® Signal Live Hub collects temperature data
from the DEWALT® signal sensor installed within a 16ft
radius via Bluetooth, and sends the data to the cloud.
®
Signal Live system