Panasonic Toughbook CF-H1CSLFZ6M Reference Manual page 96

Troubleshooting (Advanced)
Connecting Peripherals
A peripheral device does not work.
USB floppy disk drive does not work
as a boot drive.
You do not know the address map for
IRQ, I/O port address, etc.
When you use the Cradle, connect the AC adaptor to the DC-IN jack on the
Cradle.
Install the driver.
Contact the manufacturer of the device.
When operation resumes from standby or hibernation, devices such as a
mouse may not function properly. In this case, restart the computer or reinitial-
ize the device.
When is displayed in the Device Manager, remove and insert the device. If
the problem persists, restart the computer.
The computer may not recognize the connection/removal of some devices, or
may not operate normally with some devices.
Operate the following steps.
Click [start] - [Control Panel] - [Performance and Maintenance] -
A
[System] - [Hardware] - [Device Manager].
Select the device and remove the check mark for [Allow the computer
B
to turn off this device to save power.] in [Power Management]. (This
item may be unavailable for some types of devices.)
Depending on the floppy disk drive you are using, the computer may not boot
properly. The performance is confirmed by Panasonic USB floppy disk drive
(optional : CF-VFDU03U) when the computer boots from the floppy disk.
Set [Legacy USB support] to [Enabled] in the [Advanced] menu of the Setup
Utility ( page 82).
Set [Boot Option #1] in [Boot] menu of the Setup Utility to [USB Floppy Disk].
( page 83).
Turn off the computer and connect the USB floppy disk drive, and then restart
the computer.
To check the current address map, click [start] - [Control Panel] - [Performance
and Maintenance] - [System] - [Hardware] - [Device Manager] - [View] -
[Resources by type].
96