Setting For Barcode Reader - Panasonic Toughbook CF-U1AQB1G2M Supplementary Instructions Manual

Setting for Barcode Reader

The following menu opens by clicking
Connection to Barcode
(Power Saving Mode)
Connection to Barcode
(Always-On)
Disconnect Barcode Module
Confirmation Message On
Allow Code 39
Packet Mode
Exit 2D Barcode Key Emulator
The confirm message is closed in the following cases.
*1
When five seconds pass from the display message.
•
When the [Close] in the message window is clicked.
•
When the trigger button is pushed again.
•
NOTE
When the computer enters Sleep (Model with Windows Vista)/Standby (Model with
Windows XP) or Hibernation in Power Saving Mode or Always-On mode, the Barcode
Reader is disabled. [Barcode Module was disconnected by changing the power status]
message appears at the next resume timing.
In Power Saving Mode, click [OK] to reconnect with the Barcode Module.
•
In Always-On mode, click [OK] and select [Connection to Barcode (Always-On)] again
•
from the above menu to reconnect with the Barcode Module.
When the computer is shut down in Power Saving Mode or Always-On mode, the
Barcode Reader is disabled.
In Power Saving Mode, just turn on the computer to reconnect with the Barcode
•
Module.
In Always-On mode, the Barcode Module is not reconnected only by turning on the
•
computer. Select [Connection to Barcode (Always-On)] again from the above menu.
The icon may not appear when you start up the computer for the first time. In this
case, restart the computer.
icon on the notification area.
To reduce the power consumption, stop barcode reader
connection within 1 minute after reading a barcode.
Keep barcode reader active even after reading a barcode.
Stop barcode reader connection in Always-On mode or
Power Saving Mode.
If the trigger button is pressed in Power Saving Mode, "Push
Barcode Trigger again to enable Barcode." message is dis-
played to prevent operational errors.
Allow Code 39 type barcode. You can change the setting
by scanning Enable/Disable of Code39 (
Receive barcode decode data in packet mode.
Exit barcode reader operation.
*1
Page 7).
3