Table of Contents
Advertisement
NOTE
Depending on the user settings, if there is no input from a key or an external
mouse for a certain interval of time, the power to the external display and hard
disk may be turned off. The external display will resume operation when an
external mouse is used or a key is pressed.
The power to the external display may be turned off when an application soft-
ware is being installed. In this case, because it is conceivable that a selection
dialog box will be shown, do not press
resume from this condition as doing so may trigger a selection, but instead,
press a key unrelated to the direct triggering of a selection, like Ctrl .
In addition, when the computer is left alone, it automatically may enter the
standby* mode (
will resume by pressing the power switch.
Windows 2000
*
9
Setup Windows
NOTE
Until the wireless display is connected, use the external display, external key-
board, and external mouse for operations.
Windows 98
NOTE
If there is a computer with the same computer name nearby, [The following
error occurred while loading protocol number 0.] may be displayed. In this
case, press [OK]. To prevent this message from appearing the next time on,
change the name for [Computer name] in [Start] - [Settings] - [Control Panel] -
[Network] - [Identification] after the completion of the Windows setup proce-
dure.
1
Select settings for your region and your keyboard layout, then select [Next].
(for U.S.A.: United States 101)
Enter your name and select [Next].
2
The License Agreement will be displayed.
"Standby/Hibernation Functions"). The computer
: standby or hibernation
Space or Enter to attempt to
15
Advertisement
Table of Contents
