Levelling And Securing The Dishwasher; Moving The Dishwasher - Miele PFD 400 Operating Instructions Manual

Installation
Levelling and securing the dish-
washer
To guarantee stability, the dishwasher must
be secured to the worktop after levelling.
After levelling, secure the dishwasher to

the continuous worktop.
With the door open, screw into the work-
top through the holes in the front trim on
the left- and right-hand sides of the dish-
washer.
With stainless-steel or stone worktops, the
dishwasher must be secured at the sides to
the left and right adjacent cupboards with
two screws on each side.
Special screws (4 x 27/Torx T20) are sup-
plied in the accessory pack.
Holes must be drilled in the side wall in front
of the door seal for this.
In the case of built-under dishwashers, the
holes are already provided in the side walls.
The gaps between built-under dishwashers
and adjacent cabinets or machines must
not be filled with silicone sealant as this
could compromise the ventilation of the cir-
culation pump.
94
Depending on the specific built-under in-
stallation situation, the stainless steel cover
plate supplied can be attached to the lower
edge of the worktop. The stainless-steel
cover plate protects the lower edge of the
worktop against steam damage.

Moving the dishwasher

Before moving the dishwasher, screw in the
adjustable feet fully so that they do not get
damaged.
 Component damage caused by carry-
ing.
Do not lift the dishwasher by any protrud-
ing components, e.g. the control panel.
These could break off.
Do not hold onto protruding components
when moving the dishwasher.
 Damage caused by transportation us-
ing a sack truck.
Using a sack truck to subsequently move
the dishwasher may cause damage to the
machine.
Only transport the dishwasher on a sack
truck in its original packaging. For sub-
sequent moves, the dishwasher must be
placed on a continuous base to avoid
damage.