Table of Contents
Advertisement
Installing the studio card
Always ask your local dealer to install the studio card.
Before installing the studio card:
Release the static carried in the body of the person to perform the installation.
Installation can be performed more safely if an anti-static wrist strap is worn.
Touching the card without first releasing this static may cause malfunctioning.
Do not allow the metal part of the card come in contact with any other metal parts.
Studio card
2 screws 1/4" (6 mm)
1
Turn the power to the camera off
and remove any cables which are
connected to the power connector or
other connectors.
2
Loosen the 4 screws [5/16" (8 mm)]
on the rear panel of the camera, then
remove the panel itself.
3
Loosen the screws [1/4" (6 mm)]
on the optional card slot cover, then
remove the cover.
4
Align the studio card with the guides
and insert it.
Ensure the card is fully inserted.
Optional card
slot cover
4 screws 5/16" (8 mm)
5
Firmly tighten the screws [1/4" (6 mm)]
to the optional card slot.
6
Firmly secure the rear panel with the
4 screws [5/16" (8 mm)].
Note
If the screws are misplaced, use
the extra screws supplied with this
product.
- 9 -
Rear panel
Advertisement
Table of Contents
