Table of Contents
Advertisement
Installation
Install the parts of the kit to the HDW-700/700A
according to the following procedures of item 1 to 4.
1. Removing the cassette compartment
a'ssy, DC-DC converter a'ssy and
inside panel
1
Loosen the 5 screws, and remove the outside panel.
For details, refer to Maintenance Manual Part1 2-3.
2
Remove the DC-DC converter assembly.
(without screws)
3
Remove the 3 screws, and remove the cassette
compartment assembly.
For details, refer to Maintenance Manual Part1 2-5.
4
Loosen the 4 screws, and remove the inside panel.
For details, refer to Maintenance Manual Part1 2-3.
2. Installation of the antenna sheets
Install the antenna sheets to the removed cassette
compartment assembly according to the following
procedure.
1
Peel off the seals from the antenna sheet (B) and
(C), and attach the sheets on the stage assembly of
the cassette compartment assembly as shown in the
figure below.
When the antenna sheet (B) and (C) have already
been attached, it is unnecessary to replace them
with new ones.
0 to 0.5mm
Antenna sheet (C)
0 to 0.5mm
Along the line
Antenna sheet (B)
+P1.4×2.5
Stopper plate
Antenna sheet (A)×2
FL-260 flexible board
+P1.4×1.6
2
Put the 2 antenna sheets (A) on the FL-260 flexible
board one over another with the holes of them
overlapping completely.
3
Pass the FL-260 flexible board as shown in the
above figure.
4
Attach the FL-260 flexible board and 2 antenna
sheets (A) to the stage assembly with the holes of
them overlapping to the holes of the stage
assembly completely, and secure them with the 2
washer head screws (+P1.4×1.6).
5
Remove the 2 screws (+P1.4×2.5) fixing the
stopper plate, and remove the stopper plate.
6
Install the stopper plate of the kit, and secure it
with the 2 screws (+P1.4×2.5) used for securing
the old one.
7
Install the cassette compartment assembly as it was
before.
Inside
Stopper plate
Stage a'ssy
Side panel a'ssy
Stage a'ssy
(Continued)
3(US)
Advertisement
Chapters
Table of Contents
