Sealey RS22 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: BEFORE USING THIS PRODUCT, PLEASE READ THE INSTRUCTIONS CAREFULLY. MAKE CAREFUL NOTE OF SAFETY INSTRUCTIONS, WARNINGS
AND CAUTIONS. THIS PRODUCT SHOULD ONLY BE USED FOR ITS INTENDED PURPOSE. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. RETAIN THESE INSTRUCTIONS FOR FUTURE USE.
1. FEATURES
1.1. GENERAL FEATURES
! 1600 amps initial peak power for starting. May also be used in DEEP CYCLE applications.
! The Roadstart is also a portable power source for 24V DC accessories equipped with a male cigarette lighter plug. The DC outlets have
10 amp fuse protection.
! Test switch and LEDs.
1.2. SAFETY FEATURES
! Clamp storage holsters prevent accidental sparking of clamps.
! The Roadstart contains the latest technology - 24 volt output from two 12 volt sealed gel batteries. This means the Roadstart RS22 may
be stored in any position without fear of leakage.
IMPORTANT: READ SAFETY INSTRUCTIONS BEFORE ATTEMPTING TO USE THE ROADSTART.
2. SPECIFICATION
Built-in Batteries . . . . . . . .2 x 12V 17Ah sealed gel, maintenance free, re-chargeable.
DC Output . . . . . . . . . . . . .2 x 24 volts.
Boost Rate . . . . . . . . . . . .1600 amps (peak)
Cold Cranking Current . . . .600 amps
Charging Time . . . . . . . . . .20 - 22 hours with AC charging
Fuse . . . . . . . . . . . . . . . . .10 amp (for 24 volt DC power sockets).
Weight . . . . . . . . . . . . . . .14.5kg.
Dimensions . . . . . . . . . . . .360 x 380 x 160mm.
3. SAFETY INSTRUCTIONS
F  DANGER! - RISK OF EXPLOSIVE GASES.
WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY
p
OPERATION. FOR THIS REASON, IT IS VERY IMPORTANT TO READ AND FOLLOW EXACTLY THESE INSTRUCTIONS, EACH TIME YOU USE THE RS22.
IMPORTANT: To reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer and the
manufacturer of any equipment you intend to use in the vicinity of the battery. Remember to review warning marks on all products and on engines.
3.1. PERSONAL PRECAUTIONS
Ensure there is another person within hearing range, or close enough to come to your aid should a problem arise when working near
!
a lead-acid battery.
Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.
!
Wear safety eye protection and protective clothing. Avoid touching eyes while working with battery.
!
Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool, clean
!
running water for at least 15 minutes and seek immediate medical attention.
Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit current
!
high enough to weld a ring or the like to metal, which may cause severe burns.
3.2. OTHER IMPORTANT RS22 SAFETY INSTRUCTIONS
Familiarise yourself with the applications, limitations and potential hazards of the Roadstart.
!
Keep the unit in good working order and condition (take immediate action to repair or replace damaged parts).
!
Use only recommended parts. To use unapproved parts may be dangerous and will invalidate your warranty.
!
The Roadstart must only be opened and checked by qualified service personnel. DO NOT dis-assemble the RS22 for any reason.
!
Keep children and unauthorised persons away from the work area.
!
Keep work area clean and tidy and free from unrelated materials and ensure that there is adequate lighting.
!
If the RS22 receives a sharp knock or blow, it must be checked by a qualified service agent before being used.
!
When not in use re-charge every six months.
!
DO NOT smoke or allow a spark, or flame in the vicinity of the battery or engine.
%
DO NOT drop any metal tool onto the battery as it may spark or short circuit the battery, which could cause an explosion.
%
DO NOT use RS22 to recharge dry cell batteries that are commonly used with home appliances. These batteries may burst and cause
%
injury to persons and/or damage to property.
DO NOT charge or boost a frozen battery.
%
DO NOT recharge the unit for more than 36 hours continuously.
%
DO NOT allow clamps to touch each other, or to contact the same piece of metal, as this will result in arcing.
%
adaptor & 6 - 8 hours with
DC charging cable.
Instructions for:
24V ROADSTART UNIT
RS22
Model No:
RS22 - 2 - 260602