Advertisement
Prewash
Wash
Softener (do not fill above the MAX symbol )
Please read these points carefully before installing and using your appliance. Keep this user manual with your appliance.
If your appliance is exposed to temperatures below 0°C, the following precautions must be taken:
This way, the water remaining in the hoses will be drained away, avoiding any ice formation which would damage your appliance. Before turning your appliance on again, ensure that it is installed in an area where the temperature will not fall below freezing.
Using for the first time
Before closing the lid of your appliance, ensure that the drum is properly closed:
Pour the amount of washing powder into the washing and prewash compartments if you have selected the "prewash" option. Pour fabric softener into the compartment if necessary.
Turn the programme selector to the required programme. The "Start/Pause" pushbutton flashes green.
If you turn the programme selector to another programme while a cycle is in progress, the appliance will ignore the new selected programme. The "Start/Pause" pushbutton flashes red for a few seconds.
Press the "Temperature" pushbutton repeatedly to increase or decrease the temperature (see "Programmes table"). The symbol means a cold wash.
Turn the spin speed selector on the desired position.
The maximum spin speeds are:
for Cottons, Synthetics, Easy iron, Wool, Handwash: 900 rpm, for Delicates, Silk, Mini programme: 700 rpm.
At the end of the programme, if you have selected "Rinse hold" or "Night silence plus" , you then need to select a "Spin" or "Drain" programme to finish the cycle and empty the water.
You must select the different options after selecting the programme and before pressing the "Start/ Pause" pushbutton (see "Programmes table"). Press the desired button(s): the corresponding lights come on. If pressed again, the lights go out. If one of the options is not compatible with the selected programme, the "Start/Pause" pushbutton flashes red.
The appliance runs a prewash at 30°C max.
This option allows you to choose a lower temperature programme which is as effective as a higher temperature wash programme.
The washing time will be reduced depending on the programme selected.
The washing machine will add one or more rinses during the cycle. This option is recommended for people with sensitive skin and in soft water areas.
Temporary: Press the "Rinse plus" pushbutton. The option is only active for the selected programme.
Permanent: Hold down the "Temperature" and "Options" pushbuttons for a few seconds. The option is permanently activated, even if the appliance is switched off. To deactivate it, repeat the process.
This option allows you to delay the start of a wash programme by 3, 6 or 9 hours by pressing the "Delay start" pushbutton.
You can change or cancel the delayed start time at any time before you press the "Start/Pause" pushbutton by pressing the "Delay start" pushbutton again (when all indicators are off, the wash programme will start immediately).
If you have already pressed the "Start/Pause" pushbutton and you want to change or cancel the delayed start, proceed as follows:
The lid will be locked during the delayed start time. If you need to open it, you must first pause the appliance by pressing the "Start/Pause" pushbutton. After closing the lid again, press the "Start/Pause" pushbutton.
Press the "Start/Pause" pushbutton to start the cycle. The corresponding light will come on green. It is normal for the programme selector to remain stationary during the cycle. The light corresponding to the current cycle is illuminated.
: Prewash + Wash
+ : Rinses + Spin
: End of cycle
Adding washing during the first 10 minutes
Press the "Start/Pause" pushbutton: the corresponding light will flash green while the appliance is paused. The lid can only be opened around 2 minutes after the washing machine has come to a stop. Press the "Start/Pause" pushbutton again to continue the programme.
Modifying the programme in progress
Before making any changes to the current programme, you need to pause the washing machine by pressing the "Start/Pause" pushbutton. If the modification is not possible, the "Start/Pause" pushbutton flashes red for a few seconds. If you still decide to change the programme, you must cancel the current programme (see below).
Cancelling the programme
If you want to cancel the programme, turn the programme selector to the "Stop" position.
The washing machine stops automatically, the "Start/Pause" pushbutton goes out and the light "End of cycle" comes on. The lid can only be opened around 2 minutes after the washing machine has come to a stop. Turn the programme selector to the "Stop" position . Remove washing. Unplug and close water inlet tap.
If the appliance is on but no commands are selected for 10 min before or after a cycle, it goes into standby mode. All the lights go out and "Start/ Pause" flashes slowly.
To exit standby mode, simply press any pushbutton or turn the programme selector.
Programme / Type of washing | Load/Time | Possible options |
Cottons1) (cold - 90°): White or colour, e.g. normally soiled work clothes, bed linen, table linen, body linen, towels. | 5,5 kg 140-150 min | Night silence plus, Rinse hold, Prewash, Eco2), Super quick, Rinse plus, Delay start |
Synthetics (cold - 60°): Synthetic fabrics, body linen, fab, coloured farics, non-iron shirts, blouses. | 2,5 kg 90-100 min | Night silence plus, Rinse hold, Prewash, Eco2), Super quick, Rinse plus, Delay start |
Easy iron (cold - 60°): Reduces creasing and makes ironing easier. | 1,0 kg 100-110 min | Rinse hold, Prewash, Rinse plus, Delay start |
Delicates (cold - 40°): For all delicate materials, for example curtains. | 2,5 kg 60-70 min | Night silence plus, Rinse hold, Prewash, Super quick, Rinse plus, Delay start |
Wool (cold - 40°): Very delicate items carrying the "wash by hand" label. | 1,0 kg 55-65 min | Night silence plus, Rinse hold, Delay start |
Handwash (cold - 40°): Very delicate items carrying the "wash by hand" label. | 1,0 kg 55-65 min | Night silence plus, Rinse hold, Delay start |
Silk (30°): Fabric machine washable at 30°C. | 1,0 kg 25-35 min | Night silence plus, Rinse hold, Delay start |
Soak (30°): Soaking for very dirty washing. The drum stops full of water. | 5,5 kg 15-25 min | Delay start |
Mini programme (30°): For lightly soiled fabrics except for wool. | 2,5 kg 25-35 min | Delay start |
Rinses: Hand washed items can be rinsed in this programme. | 5,5 kg 50-60 min | Night silence plus, Rinse hold, Rinse plus, Delay start |
Delicate rinse: Hand washed items can be rinsed in this programme. | 2,5 kg 35-45 min | Night silence plus, Rinse hold, Rinse plus, Delay start |
Drain: Runs an empty cycle after a Rinse hold (or Night silence plus). | 5,5 kg 0-10 min | |
Spin: A spin cycle from 500 to 900 rpm after a Rinse hold (or Night silence plus). | 5,5 kg 10-20 min | Delay start |
Delicate spin: A delicate spin cycle after a Rinse hold (or Night silence plus). | 2,5 kg 5-15 min | Delay start |
1) Reference programme for test confirming to CEI 456 standard (Cottons 60° programme, Eco option): 49 L / 1,04 kWh / 170 min
2) Available with programmes with wash temperatures of 40°C and above.
Unplug the appliance before cleaning.
To descale the appliance, use an appropriate noncorrosive product designed for washing machines. Read product label for recommended amounts and how often descaling should be carried out.
Use warm soapy water to clean the exterior of the appliance. Never use alcohol, solvents or similar products.
To clean, proceed as follows:
Regularly clean out the object trap which is located at the bottom of the drum:
Check if the filter being coupled well before closing the trap to pull up and down the central wall.
To clean, proceed as follows:
Numerous checks were carried out on your appli- notice a malfunction, please refer to the sections ance before it left the factory. However, should you below before contacting the after-sales service.
Problems | Causes |
The washing machine doesn't start or doesn't fill: |
|
The appliance fills but empties straight away: |
|
The washing machine doesn't rinse or doesn't empty: |
|
You have found water around the washing machine: |
|
Wash is unsatisfactory: |
|
The appliance vibrates, is noisy: |
|
The wash cycle is much too long: |
|
The washing machine stops during a wash cycle: |
|
The lid doesn't open at the end of the cycle: |
|
Softener runs directly into the drum when filling the dispenser box: |
|
The "Start/Pause" pushbutton 1) flashes red 2): |
|
1) On some models, the auditable signals can sound
2) After solving any problems, press "Start/Pause" pushbutton to restart the interrupted programme.
Only use detergents and additives designed for use in a washing machine. We do not recommend mixing different types of detergents. This may spoil the washing. There are no restrictions on the use of powder detergents. Liquid detergents must not be used when a prewash has been selected. For cycles without prewash, they must be added via means of a dosing ball. Detergent tablets or doses must be placed in the detergent compartment of your appliance's dispenser box.
DIMENSIONS | Height | 850 mm |
Width | 400 mm | |
Depth | 600 mm | |
LINE VOLTAGE /FREQUENCY POWER CONSUMPTION | 230 V / 50 Hz 2300 W | |
WATER PRESSURE | Minimum | 0,05 MPa (0,5 bar) |
Maximum | 0,8 MPa (8 bar) | |
Connection to water supply | Type 20/27 |
Remove all protective packaging for transit before using for the first time. Keep in case needed for future transit: Transporting a non-secured appliance may damage internal components and cause leakages and malfunctions. The appliance can also be damaged through physical contact.
To install your washing machine at the same level as surrounding furniture, proceed as shown on picture 4.
Install the supplied water inlet hose at the rear of your washing machine by proceeding as follows. Do not reuse an old hose. The water inlet hose can not be extended. If it is too short, please contact the after-sales service.
Open the water inlet tap. Check there are no leaks.
Fit the U-piece on the drainage hose. Place everything in a drainage point (or in a sink) at a height of between 70 and 100 cm. Ensure it is positioned securely. Air must be able to enter the end of the hose, to avoid any risk of siphoning.
The drain hose must never be stretched. If it is too short, contact an engineer.
This washing machine must only be connected in single-phased 230 V. Check the fuse size: 13 A for 230 V. The appliance must not be connected with an extension lead or multi-plug adaptor. Ensure that the plug is earthed and that it is in accordance with current regulations.
Position the appliance on a flat and hard surface in a ventilated location. Ensure the appliance does not come into contact with the wall or other furniture. Accurate levelling avoids vibrations, noise and prevents the appliance from moving when running.
All materials carrying the symbol are recyclable. Dispose of them at a waste collection site (enquire at your local council) for collection and recycling. When disposing of your appliance, remove all parts which could be dangerous to others: cut off the power supply cable at the base of the appliance.
The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product.
To save water and energy and therefore help protect the environment, we recommend the following:
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the EWT 9120 W that isn't answered in the manual? Leave your question here.