Table of Contents
Advertisement
Overload and Overheating Protection
In case of overload and overheating, the protection device is triggered to stop operation and it is not abnormal.
After rotation stops, follow the below steps:
● Do not use the appliance repeatedly without any countermeasure.
1
Turn the switch knob to "0" position, unplug the appliance.
2
Remove attachment from motor housing. Remove accumulated food residue from the spinner/container cover.
● Remove the prohibited ingredient if used.
3
Reset the attachment, then start again. (P. EN7)
If the appliance still does not operate after performing the above, overheating protection has been activated.
Turn the switch knob to "0" position, unplug and rest the appliance for about 15 minutes or more (until motor housing
returns to a normal temperature) to release overheating protection before using again.
(If appliance still does not operate, contact Panasonic Service Centre for inspection or repair.)
Clean all detachable parts before using the appliance for the first time or when you have not used it for a while, and then
assemble them securely. (P. EN7 "How to Use" and P. EN8 "After Use" )
● Ingredients that are not recommended:
Soft fruits that produce puree and can clog the spinner – e.g. bananas, peaches, apricots etc.
Low juice ingredients which can block the product – e.g. fresh basil leaf etc.
Hard ingredients which can cause product malfunction - e.g. sugarcane, coconut etc.
● Please remove hard seeds and stones from fruit before juicing such as guava etc. Hard seeds that are difficult to be removed such as
pomegranate is prohibited for juicing.
● During initial usage, the appliances might have some unpleasant smell (slight burn smell) but this condition is normal.
● Some ingredients may produce a lot of pulps accumulate to the container cover that cause operation stop.(Overload and Overheating
Protection: refer to page EN6)
● Make sure all parts are correctly mounted before you switch on the appliance.
● Some ingredients may accumulate at the container cover and spinner. If so, please power off the juicer and clear the accumulated ingredient
before continuing for juicing to prevent leakage.
1
Release the clamp (both sides)
while pushing the container
cover.
EN6
JZ50H168_MJ-CS100HK_20221005.indb 6
JZ50H168_MJ-CS100HK_20221005.indb 6
Before Use
Handling Precautions
To disassemble
2
Lift up the container.
3
Gently lift up the food pusher
and the container cover.
4
①
Lift up the spinner.
②
Remove the spinner pad.
2023-01-05 19:37:57
2023-01-05 19:37:57
Advertisement
Chapters
Table of Contents
