HP ZL2 Quick Setup Manual

zl Module-QSG.fm Page 1 Thursday, February 27, 2014 1:31 PM
HP zl2 Module Quick Setup Guide
The module drawings in this document are for illustration purposes only and may not match your module.
1. Load the most current switch software that 
supports your module. See Specifications.
2.
Prepare for installation
To avoid personal injury or product damage, review the
"Installation precautions" on page 2.
3.
Install the modules into a switch slot
The switch can be either powered on or off.
1 Insert module into the
guides and slide it in until
it is fully inserted.
Close the extractor handles to seat the
module, and tighten the retaining
screws until just snug.
4.
Install optional transceivers
War n i n g : Avo i d di r e c t e y e e x po s u r e t o t h e b ea m
c o m i n g f r o m t h e t r an s m i t p o r t .
5.
Verify self-test
1 Fault and Test LEDs = Off
6.

7.
See the Installation and Getting Started Guide for your
module. For example, a module with a standard RJ-45 LAN
port is illustrated in the following illustration.
2 Open extractor handles
N ot e : O p er a t i o n o f e a c h po r t 's L i n k an d M o d e
L E D s d e p e n d s o n t h e s w i t c h 's M o de s e l e c t i o n .
F o r i n f o r m a t i o n o n L E D be h a v i o r, s e e t h e HP
5 4 0 0 R z l 2 I n s t a l l at i o n a nd G et t i n g S t a r t e d G u i d e.
mini-GBIC or SFP
8.
transceiver or SFP+
modules' ports
If the default port configuration is not appropriate for your
network application, configure the port(s) in the module by
using the switch console or the web browser interface. See
the HP 5400R zl2 Installation and Getting Started Guide for
information about connecting a console, and see the
Management and Configuration Guide for information
about configuring the switch and its ports.
For module documentation, go to the HP Networking website
2 Module Status LEDs = On
at: 
www.hp.com/networking/support.
Auto search on "zl modules," and select your module from the
list. Click Display selected, and then click on the links that
have Manuals listed to get on to the webpage that lists the
available manuals.
1
Connect network cables
Connect a fiber cable
Verify network connections
Link and Mode LED
(Optional) Customize the configuration for the