Sealey STW501 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instruction
protection
manual
1. SAFETY
Ensure all workshop safety rules, regulations, and conditions are complied with when using the torque wrench.
9
Maintain the wrench in good condition and replace any damaged or worn parts. Use genuine parts only. Unauthorised parts may be
9
dangerous and will invalidate the warranty.
The wrench is a precision tool, handle with care.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
9
If it is suspect that the wrench is damaged or faulty, have it checked by Sealey or one of our Service Agents.
9
DO NOT use wrench unless you have been instructed in its use by a qualified person.
8
DO NOT use any cleaner which might affect the high pressure grease with which the wrench is packed.
8
DO NOT use torque wrench as a lever bar.
8
Use of damaged hand tools, sockets, extensions and accessories may result in injury.
8
DO NOT use torque wrench as a hammer.
8
Torque wrenches not in calibration may cause damage to parts or tools.
8
DO NOT use extensions on handle as damage to torque wrench will result and will invalidate the Warranty.
8
Over tightening of fasteners may result in breakage.
8
Handle is not insulated, do not use on live electrical or high voltage circuits.
8
2. INSTRUCTIONS
Range 300-1000Nm (200-750 lbf.ft). Scales graduated in both lb.ft and Nm giving accurate results to ±4%. Calibration
tolerance in accordance with BS EN ISO 6789:2017. Every wrench is tested and supplied with an individually numbered test
certificate. Breakback design significantly reduces the risk of over torquing. Ratchet head features push-through drive to allow
torquing either clockwise or anti-clockwise. Comfortable soft grip handle. Supplied with additional tool to drive the external nut at
base of grip clockwise/anti-clockwise for easy torque adjustment/setting. Supplied in storage case.
3. SPECIFICATION
Model No: ........................................................ STW501
Drive ................................................................... 3/4"Sq
Length .............................................................. 1550mm
Range .................................. 300-1000Nm(200-750lb.ft)
4. ASSEMBLY
1
Push in Pin locator (Fig1.1) and push bar (Fig1.2) into ratchet head (Fig1.3) making sure that the pin clicks into place. The assembled bar
will look as in (fig2).
© Jack Sealey Limited
3/4"SQ DRIVE BREAKBACK TORQUE WRENCH
300-1000NM
STW501
MODEL NO:
2
Original Language Version
3
fig.1
fig.2
STW501 Issue:3 (2,5) 19/01/23