Table of Contents
Advertisement
Available languages
Available languages
English
The guard release lever should snap into one of the
alignment holes
26
on the guard collar. This ensures
that the guard is secure.
5. To remove the guard, follow steps 1–3 of these
instructions in reverse.
Fig. C
21
22
Mounting and Removing Surface
Finishing Shroud (Fig. D)
WARNING: When loosening the clamp screw, make
sure the screw remains attached to the shroud.
1. Follow the mounting and removing guard instructions
in tool manual to remove the guard from grinder.
2. Loosen the clamp adjusting screw
finishing shroud and align the tabs
finishing shroud with the slots
gear case.
3. Rotate the shroud into the desired working position.
The surface finishing shroud should be positioned
between the spindle and the operator to provide
operator protection.
8
26
7
12
on the surface
23
on the surface
24
on the grinder
Fig. D
23
24
12
4. Tighten the clamp adjusting screw
is secured to gear case.
For optimal positioning, the diamond wheel should
ride above the brushes 1/8" (3.18 mm). If diamond
wheel rides inside the shroud or stands taller than 1/4"
(6.35 mm) the shroud will not work properly.
NOTICE: If surface finishing shroud cannot be
tightened by the clamp adjusting screw, do not use
the tool and take the tool and surface finishing shroud
to a service center to repair or replace the surface
finishing shroud.
5. To remove the surface finishing shroud, loosen the
clamp adjusting screw, rotate the surface finishing
shroud to align the slots and tabs and pull up on the
surface finishing shroud.
Mounting Dry Diamond Surface Cup
Wheels (Fig. E)
Follow the mounting and using cutting wheels instructions
in the tool manual and mount the grinding wheel. DO NOT
use Type 1 cutting wheels or bonded abrasive wheels.
Dry diamond surface cup
19
use with this shroud. The inner flange washer
installed behind the wheel allowing tool free removal and
proper fit.
to ensure shroud
12
wheels are recommended for
3
should be
Advertisement
Table of Contents
