Table of Contents
Advertisement
Operator's Visibility
• This machine is equipped with mirrors and cameras to
see around the machine. Adjust the view mirrors and
cameras position so that the best visibility is obtained from
the operator's seat. If the mirrors and cameras are dirty,
immediately clean them. Also see carefully around the
machine while moving your viewpoint as need arises.
• The view mirrors and cameras position should be
adjusted whenever changing the operator for the
machine. Always take extra attention for surrounded area
during operating.
• When the machine is modified or fitted with equipment
that influences visibility, it is necessary to check again the
operator's visibility according to the ISO 5006. Contact
your authorized dealer before modifying the machine.
• This machine has the blind area created because of parts of
the base machine and/or its equipment from the operator's
seat by direct.
• Operate the machine safely with sufficient recognition this
machine has blind area from the operator's seat by direct.
• The operator's visibility according to the ISO 5006 of this
machine with standard mirrors and cameras is as follows.
Operator's visibility on a rectangular 1 m boundary close
around the machine
Operator can see the entire circumference of the height
1.5 m located at 1 m distance from the outside rectangular
boundary of the machine as illustrated.
Operator's visibility on a 12 m visibility test circle
Operator can see the entire circumference located the circle
with 12 m radius located on the ground reference plane
with its center vertically below the operator's eye point as
illustrated.
TM: test machine
RB: rectangular 1 m boundary
VTC: visibility test circle with 12 m radius
OEP: operator's eye point
SAFETY
RB
VTC
S-5
OEP
12 m
OEP
1 m
TM
1 m
SS-3231
ΤΜ
SS-3232
Advertisement
Table of Contents
