Sealey MK80 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Wear
Refer to
protective
instructions
gloves
1. SAFETY
Only use on firm, level, unobstructed surfaces which are capable of supporting the stand and wheels.
9
DO NOT overload.
8
Always load evenly with the centre of gravity of the load as near the centre as possible.
9
Apply the brakes before commencing work.
9
DO NOT stand/ride on the stand, or allow others to do so.
8
Replace or repair damaged parts. Use only recommended parts. Unauthorised parts may be dangerous and will invalidate the warranty.
9
WARNING! Failure to comply with these instructions may result in loss of load, damage to the rack or other property and/or personal
‰
injury.
WARNING! The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions
‰
and situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this
product, but must be applied by the operator.
2. INTRODUCTION
Adjustable height from 1.3m to 1.95m. Six hooks with a combined capacity of 75kg for hanging small parts. Suitable for hanging
bumpers, bonnets, doors, wings and spoilers. Fitted with four castors, two with brakes for maximum manoeuvrability and safe
positioning.
3. SPECIFICATION
Model No: ..............................................................MK80
Max. Capacity: ....................................................... 75kg
Maximum Height: ............................................. 1950mm
Minimum Height: .............................................. 1300mm
4. ASSEMBLY
4.1. Start assembly by attaching the base of the frame (1 & 3) together with the frame bracket clamp (6).
4.2. Attach the 4 wheels (10) to the base of the frame, and lock the brake on the 2 with brakes, before the next step.
4.3. Build upwards, by joining the vertical frame parts (2 & 5) with the adjusting pins (9) and set to the desired height.
4.4. Complete the frame by attaching the top frame (4) and securing with the frame bracket clamp (6).
4.5. Attach the 6 hanging hooks as required (7).
4.6. See diagram & parts list on page 2.
© Jack Sealey Limited
1.95M ADJUSTABLE PAINT HANGER
MK80
MODEL NO:
Wear Wear eye
protective protection
footwear
Original Language Version MK80 Issue 2 02/02/23