Brother MFC-J6959DW Quick Setup Manual

Quick Setup Guide
MFC-J6959DW
Read the Product Safety Guide first, then read this Quick Setup Guide for the correct installation procedure.
EN
1
Unpack the machine and check the components
Remove the protective tape or film covering the machine and the supplies. The components included in the box may differ depending on your country.
• The images in this guide are for illustration purposes only and may differ from the
actual products.
2
Load plain A4 paper in Tray #1
Pull Tray #1 completely out of
the machine as shown by the
arrow.
3
Connect the power cord
5
Install the inbox ink cartridges
Open the ink cartridge cover.
7
Check the print quality
Follow the LCD instructions, Follow the LCD instructions and
and then press [Start].
check the quality of the four
The machine prints the Print colour blocks on the sheet, and
Quality Check Sheet. then start the cleaning procedure
if required.
Video setup instructions:
support.brother.com/videos
Fan the paper well. Load the paper in the tray
and adjust the paper guides.
NOTE
You can adjust the control panel
angle to read the LCD more easily.
Quickly shake just the black
ink cartridge horizontally
15 times as shown, before
inserting it into the machine.
8
OK Poor
Follow the LCD instructions
to print the Adjustment
Sheet. The black circle mark
is located in the upper right
corner of the sheet.
The latest manuals are available at the Brother support website:
support.brother.com/manuals
NOTE
• Save all packing materials and the box in case you must ship your machine.
• You must purchase the correct interface cable for the interface you want to use.
USB cable
Use a USB 2.0 cable (Type A/B) that is no more than 5 metres long.
Ethernet (Network) cable
Use a straight-through Category 5 (or greater) twisted-pair cable for 10BASE-T or
100BASE-TX Fast Ethernet Network.
• Brother aims to reduce waste and save both raw materials and the energy required to
produce them. Read more about our environmental work at www.brotherearth.com.
After finishing the machine setup, you can change the paper type or size. For more information
about paper handling, see the Online User's Guide at support.brother.com/manuals.
Do not exceed
this mark (bbb).
Slowly push Tray #1
completely into the machine.
4
Select your country or language
After turning the machine on, you may need to set your country or language (depending on
your machine). If required, follow the LCD instructions.
Follow the LCD instructions to
install the ink cartridges. Close the
ink cartridge cover. The machine
will prepare the ink tube system for
printing.
NOTE
The first time you install a set of ink
cartridges the machine will use an
amount of ink to fill the ink delivery
tubes for high quality printouts. This
process will only happen once.
Adjust the print alignment (recommended)
To adjust the print alignment before using your machine, press [Start].
Place the Adjustment Sheet
face down on the scanner
glass. Make sure the black
circle is in the upper left corner
of the scanner glass.
D028LH001-00
UK
Version 0
Pull out the paper support until
it locks into place.
6
Set the date and time
Follow the LCD instructions to set the date
and time.
After setting the date and time, you can set
the Brother LCD message defaults.
Follow the LCD instructions
and complete adjusting the
alignment.
When finished, remove the
Adjustment Sheet from the
scanner glass.