Remove The Back Bracket - Lenovo ThinkSmart View Plus Hardware Maintenance Manual

Removal steps
Attention: Use the screws provided by Lenovo to avoid any unpredictable damage to your device.
Step Screw (quantity)
5
M3 × 3.5 mm, flat-head (4)

Remove the back bracket

Prerequisite
Turn off ThinkSmart View Plus and wait several minutes until it is cool.
For access, do the following:
1. Remove the cable tie. See "Remove the cable tie" on page 14.
2. Remove the camera module. See "Remove the camera module" on page 15.
3. Remove the Soundbar. See "Remove the Soundbar" on page 15.
4. Remove the Stylus Pen. See "Remove the Stylus Pen" on page 16.
5. Disconnect the power cord from electrical outlet and disconnect all the cables from the device.
Torque
Color
Black 0.18±0.05 Nm
(1.8±0.5 kgf-cm)
.
Chapter 3 Hardware removal and installation
31