Installing Codeplus Transcoder Cards - LG CodePlus HCS6150R Series Installation & Setup Manual

Installing CodePlus Transcoder Cards

HCS7700
ASI OUT
HDMI-IN
RESET
STATUS
SERVICE
PORT
X PORT LINK
S/N XXXXXXX
MAC ADDRESS
XX XX XX XX XX
Note: The CodePlus series products are NOT designed to be hot-swappable!!! Power
must be removed to the HCS6150R before any CodePlus cards are inserted or removed.
Note: All cards used in the HCS6150R must be inserted and removed by qualified
service personnel only.
Note: Use extreme care when handling a transcoder card. Always observe proper
precautions with respect to static electricity and mechanical shock. When not installed
in a card frame, return the transcoder card to the anti-static bag in which it was shipped.
Note: No more than eight HCS7700, HCS7710, or HCS7720 cards may be installed in
the HCS6150R card frame. Cards should be inserted in the following slots: 1, 2, 4, 5, 8,
9, 11, and 12. HCS6400 fan cards are pre-installed in the following slots: 3, 6, 7, and 10.
Note: The card slots in the HCS6150R are NOT all identical!!! See also "Back Panel
Overview" on pages 8 to 9. The CONTROLLER slot between Slots 6 and 7 is dedicated
for optional feature cards and is not compatible with HCS7700/HCS7710/HCS7720 cards.
1. Unpack the CodePlus transcoder card(s) and all accessories.
2. Select the slot(s) in the card frame in which to install the transcoder card(s). Note: All
cards must be used in an LG-approved card frame for this product.
3. If applicable, remove the HCS6150R AC power cord from the power outlet.
4. Remove the blank cover plate from each slot into which a card is to be inserted.
5. Without using force, slide each new card into its designated slot, and ensure it is fully
inserted.
6. Engage and tighten the top and bottom thumbscrews securely. Note that the thumb-
screws should only be finger tight; overtightening may damage the assembly.
7. Refer to the Installation & Setup Guide for the individual transcoder card(s) for cabling and
setup information.
Note: If applicable, repeat steps 1 to 7 for the feature card to be installed. The feature
card will be installed in the CONTROLLER SLOT.
10
HCS7700
HCS7700 HCS6400
ASI OUT
ASI OUT
HDMI-IN
HDMI-IN
RESET
STATUS
RESET
SERVICE
PORT
STATUS
X PORT LINK
SERVICE
PORT
X PORT LINK
S/N XXXXXXX
MAC ADDRESS
XX XX XX XX XX
S/N XXXXXXX
MAC ADDRESS
XX XX XX XX XX
HCS6400 HCS7700 HCS7700 HCS6400 HCS7700
HCS6300
ETHERNET
ASI OUT ASI OUT
SERVICE
PORT
HDMI-IN HDMI-IN HDMI-IN
RESET
RESET RESET
STATUS
STATUS STATUS
SERVICE SERVICE
RF OUT
PORT PORT
X PORT LINK X PORT LINK
S/N XXXXXXX S/N XXXXXXX S/N XXXXXXX
MAC ADDRESS MAC ADDRESS MAC ADDRESS
XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX
HCS7700
ASI OUT ASI OUT
HDMI-IN
RESET RESET
STATUS STATUS
SERVICE SERVICE
PORT PORT
X PORT LINK X PORT LINK
S/N XXXXXXX
MAC ADDRESS
XX XX XX XX XX
206-4138