Replacing The Hydraulic Filter; Changing The Hydraulic Fluid - Toro 08743 Operator's Manual

Replacing the Hydraulic
Filter
Service Interval: Every 1,000 hours—If you
are using the recommended
hydraulic fluid, replace the
hydraulic filter.
Every 800 hours—If you are not using the
recommended hydraulic fluid or have ever
filled the reservoir with an alternative fluid,
replace the hydraulic filter.
1. Park the machine on a level surface, shut off the
engine, engage the parking brake, and remove
the key.
2. Loosen the 2 screws securing the center shroud
to the machine and remove the shroud
41).
Figure 41
1. Center shroud
3. Lubricate the sealing gasket on the replacement
filter with clean hydraulic fluid.
4. Place a drain pan under the hydraulic filter,
which is located at the left side of the machine
(Figure 42).
(Figure
1. Hydraulic filter
5. Clean the area around the filter mounting area.
Note:
before removing the old filter.
6. Remove the hydraulic filter from the filter head.
7. Install the new hydraulic filter
turning it on by hand until the gasket contacts the
filter head, then tighten the filter 3/4 turn further.
8. Check the hydraulic fluid level and add the
specified hydraulic fluid as needed; refer to
g002727
Checking the Hydraulic-Fluid Level (page 32)
9. Install the center shroud.
Changing the Hydraulic
Fluid
Service Interval: Every 2,000 hours—If you
Every 800 hours—If you are not using the
recommended hydraulic fluid or have ever
filled the reservoir with an alternative fluid,
change the hydraulic fluid.
Reservoir capacity: 26.5 L (7.0 US gallons)
Use a genuine Toro filter for replacement; refer to the
Parts Catalog for your machine.
1. Remove the cap from the hydraulic reservoir
(Figure
33
Figure 42
Have the replacement filter within reach
are using the recommended
hydraulic fluid, change the
hydraulic fluid.
43).
g339957
(Figure 42) by