Operation; Charging The Battery Pack - Toro 88625 Operator's Manual

Operation

Charging the Battery Pack

Important:
The battery pack is not fully charged
when you purchase it. Before using the tool for
the first time, place the battery pack in the charger
and charge it until the LED display indicates the
battery pack is fully charged. Read all safety
precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1. Make sure that the vents on the battery are clear
of any dust and debris.
2. Line up the cavity in the battery pack
with the tongue on the charger.
1. Battery pack cavity
2. Battery pack venting areas 5. LED indicators (current
3. Battery pack terminals
3. Make sure that the vents on the battery charger
are clear of any dust and debris.
4. Slide the battery pack into the charger until it is
fully seated (Figure
6).
(Figure
Figure 2
4. Handle
charge)
6. Battery-charge-indicator
button
3).
1. LED indicator light
2)
2. Charger venting areas
5. To remove the battery pack, slide the battery
backward out of the charger.
6. Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator light
Off
Green blinking
Green
Red
Red blinking
*Refer to
g282651
information.
7
Figure 3
Indicates
No battery pack inserted
Battery pack is charging
Battery pack is charged
Battery pack and/or battery
charger is over or under the
appropriate temperature range
Battery pack charging fault*
Troubleshooting (page 9)
g268087
for more