Advertisement
TIMER OPERATION
Setting the ON Timer
1. Press
: Set the desired ON timer.
2. Press
: Set the timer.
3. Press
: Cancel the timer.
Every timer allows the user to set both the ON & OFF timers and will be activated on a daily basis.
Setting Combined Timer
1. Press
: Set the ON timer.
2. Press
: Set the OFF timer.
3. Press
.
4. Press
button during the (
or
•
During the every day timer is activating, both arrows (
Note:
•
Keep the remote control in accessible transmission to the indoor unit; otherwise, the time lag of up to 15 minutes
will occur.
•
The setting will be saved for the next same operation.
PRESET OPERATION
Set your preferred operation for future use. The setting will be memorized by the unit for future operation (except airflow
direction).
1. Select your preferred operation.
2. Press and hold
for 3 seconds to memorize the setting. The
3. Press
: Operate the preset operation.
AUTO RESTART OPERATION
To automatically restart the conditioner after the power failure (Power of the unit must be on.)
Setting
1. Push and hold the TEMPORARY/RESET button for 3 seconds to set the operation (operation lamp : orange).
•
Do not operate on TIMER operation.
2. Push and hold the TEMPORARY/RESET button for 3 seconds to cancel the operation (operation lamp : green).
QUIET OPERATION
To operate at super low fan speed for quiet operation (except in DRY mode)
1. Press
: Start and stop the operation.
COMFORT SLEEP OPERATION
To save energy while sleeping
1. Press
: Select 1, 3, 5 or 9 hrs for OFF timer operation.
Note: The set temperature will increase automatically 1 degree/hour for 2 hours (maximum 2 degrees increase).
SLEEP TIMER OPERATION
To start the sleep timer (OFF timer) operation
1. Press
: Select 1, 3, 5 or 9 hrs for OFF timer operation.
MAINTENANCE
Firstly, turn off the circuit breaker.
Filter Reset
FILTER lamp lights on; the filter must be cleaned.
To turn off the lamp, push the TEMPORARY/RESET button on the indoor unit.
Indoor Unit and Remote Control
•
Clean the indoor unit and the remote control with a wet cloth when needed.
•
No benzine, thinner, polishing powder or chemically-treated duster.
Air Inlet Grille
1. Open and remove the air inlet grille.
2. Wash it with a sponge or a towel and dry it.
3. Reinstall and close it.
SELF CLEANING OPERATION (COOL AND DRY OPERATION ONLY)
To protect bad smell caused by the humidity in the indoor unit.
1. If the
button is pressed once during "Cool" or "dry" mode, the fan will continue to run for other 20 minutes, then
it will turn off automatically. This will reduce the moisture in the indoor unit.
2. To stop the unit immediately, press the
Setting the OFF Timer
1. Press
: Set the desired OFF timer.
2. Press
: Set the timer.
3. Press
: Cancel the timer.
) mark flashing.
,
) are indicated.
mark displays.
3 times within 30 seconds.
Advertisement
