Setting Up And Connecting; Operation - AEG DVD 4556 LCD Instruction Manual

Unpacking
Setting Up
(when using an AC adapter;
not included)
Head-rest Mounting
Insert / Replace Batteries into the
Remote Control
DVD4556LCD_IM

Setting Up and Connecting

Please unpack the device and all accessories and check the contents for com-
pleteness.
CAUTION:
Always transport / send the device in the original packing to avoid damages.
Retain the original packing materials for this purpose. Recycle useless packing
material in accordance with your countries regulations.
NOTE:
Get in touch with your dealer immediately if you notice damage caused by
transport.
1. Fold out the stand at the rear of the DVD Monitor.
2. Place the device on a stable, level and flat surface. Maintain a distance of a
minimum of 10 cm from walls and other objects.
3. Connect the device to an outlet installed according to regulations.
4. Remove protective cover from device / LCD Screen if applicable.
You will need two fastening strips to fit each device.
WARNING:
The fixing belts are not suitable for use while driving. Risk of injuries!
NOTE:
The supplied fixing belts are only intended for use while the vehicle is parked.
1. Thread a strap through the clamps on the back of the device.
2. Fix the device now horizontally to the back of the head-rest.
3. Fasten the horizontal strap to the other strap. Run it vertically around the
headrest.

Operation

WARNING:
Leaking battery acid may cause a health hazard. Remove batteries from the
remote control when depleted or the device is not in use for an extended
period of time. Clean up any leakage with a cloth immediately. In the event of
skin contact, rinse the affected area immediately. In case of ingestion consult
a physician immediately. In the event of eye contact, rinse eyes and consult a
physician immediately.
CAUTION:
Upon disposal, adhere to the recycle and environmental regulations of your
respective country. Never throw batteries into open fire.
English
37
16.12.16