Connecting The Units; Installation - Pioneer DEH-P860MP Premier Installation Manual

Connecting the Units

Connection diagram for 3-way network mode
DSP switch
Switch the DSP switch
as illustration below.
15 cm (5-7/8 in.)
This product
Antenna jack
IP-BUS input
(Blue)
Jack for the Wired Remote Control
Refer to Wired Remote Control's manual
IP-BUS cable
(sold separately).
Multi-CD player
(sold separately)
Yellow/black
If you use a cellular telephone, connect
it via the Audio Mute lead on the
cellular telephone. If not, keep the
Audio Mute lead free of any
connections.
Yellow
Fuse holder
To terminal always supplied with
power regardless of ignition switch
position.
Red Fuse resistor
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
Orange/white Fuse resistor
To lighting switch terminal.
Black (ground)
With a 2 speaker system, do not
To vehicle (metal) body.
connect anything to the speaker leads
This terminal may or may
that are not connected to speakers.
not be included.
Perform these connections when using
the optional amplifier.
External amp is required for
connecting the low range speaker.
Connecting cords with RCA pin
23 cm (9 in.)
plugs (sold separately)
Low range output
(LOW/SUBWOOFER OUTPUT)
Middle range output
(MID/REAR OUTPUT)
High range output
(HIGH/FRONT OUTPUT)
15 cm (5-7/8 in.)
Blue/white System remote control
To system control terminal of the power amp or
Auto-antenna relay control terminal (max. 300
mA 12 V DC).
+ +
High range speaker High range speaker
≠ ≠
White Gray
+ +
High range speaker High range speaker
≠ ≠
White/black Gray/black
Left
Green Violet
+ +
Middle range speaker Middle range speaker
≠ ≠
Green/black Violet/black
+ +
Middle range speaker Middle range speaker
≠ ≠
+ +
Low range speaker Low range speaker
≠ ≠
<ENGLISH>

Installation

Note:
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all connected
up properly, and the unit and the system work
properly.
Power amp
• Use only the parts included with the unit to ensure
(sold separately)
proper installation. The use of unauthorized parts
can cause malfunctions.
• Consult with your nearest dealer if installation
Power amp
requires the drilling of holes or other modifications
(sold separately)
of the vehicle.
• Install the unit where it does not get in the driver's
way and cannot injure the passenger if there is a
Power amp
sudden stop, like an emergency stop.
(sold separately)
• The semiconductor laser will be damaged if it
overheats, so don't install the unit anywhere hot
— for instance, near a heater outlet.
Right
Fig. 3
DIN Front/Rear-mount
• If installation angle exceeds 60° from horizontal,
the unit might not give its optimum performance. This unit can be properly installed either from "Front" (conventional DIN Front-mount) or
(Fig. 4)
"Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit
chassis). For details, refer to the following illustrated installation methods.
DIN Front-mount
60°
Installation with the rubber bush (Fig. 6)
Fig. 4
Dashboard
• The cords must not cover up the area shown in the
figure below. This is necessary to allow the ampli-
fires to radiate freely. (Fig. 5)
Fig. 5
<ENGLISH>
Holder
After inserting the holder into the dash-
board, then select the appropriate tabs
according to the thickness of the dash-
board material and bend them.
(Install as firmly possible using the top
182 and bottom tabs. To secure, bend the
tabs 90 degrees.)
53
Rubber bush
Screw
Fig. 6