Husqvarna DE 110 SH Operator's Manual page 17

1. Loosen the cover locks (A) and open the prefilter
cover (B).
A
B
2. Remove the prefilter.
1587 - 011 - 06.03.2023
3. Clean the prefilter with running water from the inner
surface of the prefilter.
CAUTION:
must not be higher than 4 bars.
CAUTION:
across the filter surface as this will do
damage to the filter.
4. Let the prefilter dry fully.
CAUTION:
100% dry before you install it into the
housing.
5. Install the prefilter, close the prefilter cover and
tighten the cover locks.
If the prefilter cannot be fully cleaned or if it is damaged,
it must be replaced. Refer to
page 17 .
Filter replacement
WARNING:
equipment. Refer to
equipment on page 7 . Dangerous dust can
release into the air during filter replacement.
WARNING:
disconnect the power supply before filter
replacement.
To replace the prefilter
1. Remove the prefilter. Refer to
with water on page 16 .
2. Put the prefilter carefully in a plastic bag.
The water pressure
Do not hit or drag items
The prefilter must be
To replace the prefilter on
Use personal protective
Personal protective
Stop the product and
To clean the prefilter
17