Table of Contents
Advertisement
•
Do not place sharp metal objects such as pins near the earpiece. The
earpiece may attract these objects and hurt you when you are using the
device.
•
Before you clean or maintain the device, power off the device and
disconnect it from the charger.
•
Do not use any chemical detergent, powder, or other chemical agents
(such as alcohol and benzene) to clean the device and the charger.
Otherwise, parts of the device may be damaged or a fire can be caused.
You can clean the device and the charger with a piece of damp and soft
antistatic cloth.
•
Do not dismantle the device or accessories. Otherwise, the warranty on
the device and accessories is invalid and the manufacturer is not liable to
pay for the damage.
•
If the device screen is broken by colliding with hard objects, do not touch or
try to remove the broken part. In this case, stop using the device
immediately, and then contact an authorized service center in time.
Emergency Call
You can use your device for emergency calls in the service area. The
connection, however, cannot be guaranteed in all conditions. You should not
rely solely on the device for essential communications.
Certification Information (SAR)
This device meets guidelines for exposure to radio waves.
Your device is a low-power radio transmitter and receiver. As recommended
by international guidelines, the device is designed not to exceed the limits for
exposure to radio waves. These guidelines were developed by the
independent scientific organization International Commission on Non-Ionizing
Radiation Protection (ICNIRP) and include safety measures designed to
ensure safety for all users, regardless of age and health.
The Specific Absorption Rate (SAR) is the unit of measurement for the
amount of radio frequency energy absorbed by the body when using a device.
The SAR value is determined at the highest certified power level in laboratory
conditions, but the actual SAR level of the device when being operated can be
well below the value. This is because the device is designed to use the
minimum power required to reach the network.
15
Advertisement
Table of Contents
