Table of Contents
Advertisement
CHAPTER -10: TROUBLESHOOTING
FAULT
Excessive foam is formed in the
detergent drawer.
Unsatisfactory washing result.
As soon as the machine is loaded
with water, water discharges.
No water appears in the drum
during washing.
Laundries have detergent
residues on them.
Grey spots appear on the
laundries.
Spinning operation is not
performed or runs late.
(**) See the chapter regarding installation of your machine.
POSSIBLE CAUSE
Excessive amount of detergent
used.
Wrong detergent used.
The contamination degree of your
laundries does not match the
programme you have chosen.
Amount of detergent used
insufficient.
Laundries in excess of maximum
capacity put in your machine.
Water being hard.
( Contaminated, lime water etc.)
Laundries distributed in your
machine non-homogenously.
The end of water discharging hose
is too low for the machine.
No fault. Water is in the unseen
part of the drum.
Non-dissolving particles of some
detergents may stick to your
laundries as white spots.
The reason for such spots may be
oil, cream or ointment.
No fault. Unbalanced load control
system has been activated.
EN -18-
TROUBLESHOOTING
Press on Start/Pause button To
eliminate foam formation, mix a
spoon of softener with half litres
of water, and pour the mixture in
the detergent drawer. After 5-10
minutes, press on Start/Pause
button again. In your next washing
operation, Adjust the detergent
dose accordingly.
Use detergents produced only for
automatic washing machines in
your machine.
Select the programme appropriate
for the contamination degree of
your laundries. (See programme
table)
Adjust the amount of detergent
based on the amount and
contamination degree of your
laundries.
Load your machine with laundries,
amount of which will not exceed
maximum laundry capacity.
Adjust the amount of detergent
based on the instruction of
detergent manufacturer.
Spread your laundries in
the machine properly and
homogeneously.
Set the water discharging hose on
appropriate height. (**)
-
Perform an extra rinsing by
setting your machine to "Rinsing"
programme, or clean the spots
using a brush after your laundries
dry.
Apply the maximum amount
of detergent instructed by the
detergent manufacturer in the next
washing operation.
Unbalanced load control system
will try to spread your laundries
homogeneously. Wringling
operation will begin after your
laundry is spread. Place the
laundry in the machine in a
balanced fashion the next time.
Advertisement
Table of Contents
