Canon imagePRESS P400 Service Manual page 50

2. Replace the cover on the imagePRESS Server.
Make sure that all cables are fully inside the chassis before you replace the cover. Slide the cover until it engages the edge
of the chassis opposite the connector panel, and then lower the cover.
3. Replace the two screws that you removed earlier.
Tighten the screws to secure the cover to the imagePRESS Server.
4. Reinstall the imagePRESS Server on the side of the printer.
For detailed information about removing/installing the printer, see the installation instructions that accompany the printer (not
included in this service guide).
5. Reinstall the bracket as necessary.
6. Connect the external cables that you removed during inspection or service. Be sure to properly connect the
following cables:
• Network cable
• Crossover Ethernet cable between the imagePRESS Server and printer
• Printer interface cable
• imagePRESS Server power cable
7. If you installed a new HDD, install system software (see
A spare HDD is shipped without preinstalled system software.
8. Make sure to configure the date and time in Setup (see
9. Before you leave the customer site, verify the imagePRESS Server operation.
• Connect the imagePRESS Server to the network (see
• Ask the site administrator to check the Setup options (see Configuration and Setup).
Figure 24: Replacing the chassis cover
"Installing system software" on page
"Configure the system date and time" on page
"Check internal cable connections" on page
44
3. REPLACING PARTS
46).
25).
19).