Adjusting The Height Of Cut; Adjusting The Anti-Scalp Rollers - Toro TimeCutter SS 5425 Operator's Manual

Adjusting the Height of Cut

Note: The transport position is the highest height-of-cut
position at 115 mm (4-1/2 inches) as shown in
Adjusting the Anti-Scalp
Rollers
Machines with a 42-inch, 50-inch, or
54-inch Mower Deck Only
Whenever you change the height of cut, adjust the height
of the anti-scalp rollers.
Note: Adjust the anti-scalp rollers so that the rollers do not
touch the ground in normal, flat mowing areas.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the P
engage the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Adjust the anti-scalp rollers as shown in
match the closest height-of-cut position.
Figure
Figure 25
position, and
ARK
Figure 26
25.
G010233
1. Anti-scalp roller
2. Bolt
Machines with a 60-inch Deck Only
Whenever you change the height of cut, it is recommended to
adjust the height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the P
engage the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the flange nut, anti-scalp roller, and bolt from
the bracket
Note: Keep the bolt and anti-scalp roller together
g028025
when removing.
1
1. Flange nut
2. Spacer
3. Anti-scalp roller
4. Align the bolt and anti-scalp roller in the hole of the
bracket that matched the closest height-of-cut position
(Figure
5. Insert the bolt into the bracket hole and secure the bolt
and anti-scalp roller with the flange nut
to
25
4
3
1
2
Figure 26
3. Flange nut
4. Hole spacing
(Figure 27).
2 3 4
Figure 27
4. Bushing
5. Bolt
27).
g010233
position, and
ARK
5
g024312
g024312
(Figure 27).