LG WD14030D6 Service Manual page 8

3
se spanner to remove transit bolts.
4 Confirm the distance between the appliance and the wall.
More than 2cm
5 The tap connection and hose connection must be parallel.
1. Normal Tap without thread &
nscrew the fixing screw to
1.
attach the tap.
pper
Connector
Fixing screw
2. Normal Tap without thread &
ntighten the upper connector
1.
screw.
pper
Connector
Fixing screw
• In case the diameter of the tap
is large remove the guide plate.
Guide plate
Transit bolts
screw type inlet hose.
Push the connector up till the
2.
rubber packing is in tight contact
with the tap. Then tighten the 4
screws.
Rubber
packing
Rubber packing
pper
Connector
one touch
Push the upper connector up
2.
till the rubber packing is in
tight contact with the tap. Then
Rubber tighten the 4 screws.
packing
Middle
connector
• Turn the middle connector not to
have water leaked.
• Make sure that the rubber seal is
inside the hose connector.
Connector
Hose connector
X 4 EA
If the distance is less than 2cm,
the water supply hose will
or .
kink fold
type inlet hose (Single inlet models)
Rubber packing
pper
Connector
Middle
connector
Rubber seal
8
Without removal of transit bolts
and
pin noise shaking
Push the water supply hose
3.
vertically upwards so that the
rubber packing within in the hose
can adhere completely to the tap
and then tighten it by screwing it
to the right.
pper
Connector
Plate
Water supply
hose
Connect the water supply hose
3.
to the middle connector, pushing
the plate down.
pper
Connector
Water supply
hose
• To separate the water supply
hose from the middle connector
shut off the tap.
Then pull the inlet hose down,
pushing the plate down.
• Make sure that there are no
kinks in the hose and that it is
not crushed.
.
Plate