Table of Contents
Advertisement
Error code
Internal fail. No communication be‐
tween electronic elements of the
appliance.
E97
The mains supply is unstable.
EH0
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
11.2 Troubleshooting
Problem
The tumble dryer is not connected
to the mains supply.
The door is open.
The tumble dry‐
The
er does not op‐
pushed.
erate.
The
not touched.
The appliance is in standby mode.
Possible cause
Possible cause
On/Off button was not
Start/Pause button was
Remedy
The programme was not finished
properly or the appliance stoped
too early. Switch the appliance off
and on again.
If the error code appears again,
contact the Authorised Service
Centre.
When the appliance is showing
EH0, please wait until main supply
is stable than press start. If the ap‐
pliance pause the cycle without
any indication then press the cycle
start. If the warning will occur
check the power cord / socket in‐
tegrity or main supply.
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
Close the door.
Push the
On/Off button.
Touch the
Start/Pause button.
Push the
On/Off button.
ENGLISH
21
Advertisement
Table of Contents
