Sealey AB1008.V3 Instructions Manual

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to Warning:
instructions Hot surface
1. safetY
1.1. electrical safetY
warninG! it is the user's responsibility to check the following:
‰
check all electrical equipment and appliances to ensure that they are safe before using. inspect power supply leads, plugs and all
electrical connections for wear and damage. sealey recommend that an rcd (residual current device) is used with all electrical
products. You may obtain an rcd by contacting your local sealey dealer.
if the heater is used in the course of business duties, it must be maintained in a safe condition and routinely PAt (Portable Appliance
test) tested.
electrical safety information, it is important that the following information is read and understood.
1.1.1. ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
1.1.2. regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
1.1.3. important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the correct
fuse - see fuse rating in these instructions.
do not pull or carry the appliance by the power cable.
8
do not pull the plug from the socket by the cable.
8
do not use worn or damaged cables, plugs or connectors. ensure that any faulty item is repaired or
8
replaced immediately by a qualified electrician.
1.1.4. This product is fitted with a BS1363/A 13 Amp 3 pin plug.
if the cable or plug is damaged during use, switch the electricity supply and remove from use.
Ensure that repairs are carried out by a qualified electrician.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
a) Connect the GREEN/YELLOW earth wire to the earth terminal 'E'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal 'N'.
ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
Sealey recommend that repairs are carried out by a qualified electrician.
1.1.10 if an extension reel is used it should be fully unwound before connection. A reel with an rcd fitted is
preferred since any appliance plugged into it will be protected. the cable core section is important and
should be at least 1.5mm², but to be absolutely sure that the capacity of the reel is suitable for this product and for others which may be
used in the other output sockets, we recommend the use of 2.5mm² section cable.
General safetY
1.2.
▲ danGer! risk of carbon monoxide poisoning. failure to provide proper ventilation could result in serious illness or death.
check that the heater is in sound condition and good working order. take immediate action to repair or replace damaged parts.
9
use recommended parts only. unapproved parts may be dangerous and will invalidate the warranty.
9
warninG! Only use clean paraffin, kerosene or diesel (NOT BIO-DIESEL) to fuel your heater, in accordance with instructions
‰
contained in this manual.
warninG! Keep spare fuel in suitable containers and away from sources of heat or ignition.
‰
Keep the front of the heater a minimum of 2.5 metres from any combustible materials (i.e. wooden items, cloth, plastics, paper,
9
tarpaulins etc).
only operate on a level and stable surface.
9
warninG! do not use the heater near flammable material, liquids, solids, gases or compressed gas cylinders.
‰
do not use the heater in closed rooms, living areas, basements or below ground level.
8
do not allow untrained persons to operate the heater and do not operate the heater without the cover.
8
do not move or handle the heater when hot.
8
do not leave the heater unattended when in use. switch the heater off and unplug from the mains before leaving work area.
8
do not fill the fuel tank whilst the heater is running or still hot. Stop heater and allow to cool before refuelling.
8
do not overfill the fuel container. Wipe up any spilt fuel immediately.
8
do not obstruct the air inlet (rear) and air outlet (front) of the heater.
8
do not use duct work in front or at the rear of the heater.
8
do not allow children or animals near the heater when in use, or while hot.
8
© Jack sealey limited
instructions for
space warmer paraffin/kerosene/diesel
heater
model no's:
Warning:
Automatic
start up
Original Language Version
aB1008.V3, aB1258.V3, aB1758.V3
AB1008.V3, AB1258.V3, AB1758.V3| Issue:1 11/08/17
recommended fuse rating
5 Amp