HP MP200 User Manual page 22

Wireless LAN setup: Before configuring the wireless network, insert the USB Wireless
Adapter into one of the USB 2.0 ports on the front of the mp200.
To setup the wireless connection, the mp200 will walk you through the steps below.
During each step, you can press the "OK" button to continue, or press the "RETURN"
button to go back to the previous step.
Profile
Connection
Profile
Profile: Choose one profile to edit or apply. The saved profile can be applied later. To
apply the profile, choose it and press blue button to apply. In the first setting, choose
"Connection 1" and press the "OK" button to continue.
Connection: Select to use either the "Infrastructure (AP)" or "Peer to Peer (Ad Hoc)"
modes. If you have a home router, you would typically choose "Infrastructure (AP)".
If your home network does not include a router, then choose "Peer to Peer (Ad Hoc)"
mode.
The following wireless setup procedure is divided into two sections, depending on which
mode your wireless network uses (Infrastructure/AP vs. Peer to Peer/Ad Hoc).
Wireless Wireless Setup
Get SSID
Infra AP
(Scan WLAN)
1. Setup SSID
Peer to Peer
Ad Hoc
2. Security
Security Setup
Enter the key
Enter the key
18
IP Setup
DHCP
OK
FIX IP
OK
FIX IP