Philips S9321 Manual page 27

3
2
_S9321.indd 29
C
◗ During the drying phase, the drying symbol
lights up continuously.
±4 hrs.
◗ The drying phase takes approximately 4 hours.
◗ Do not press the ON/OFF button while the
cleaning cycle is running. If this does occur,
the cleaning cycle will stop and the cleaning or
drying symbol stops blinking. The cleaning cycle
can be re-started by pressing the ON/OFF
button once.
◗ If the power plug is disconnected before the
cleaning cycle is complete, reconnect the plug
into the outlet and the cleaning cycle can be
re-started by pressing the ON/OFF button
once.
C
NOTE: When the cleaning cartridge filter is full,
the replacement symbol blinks orange. (See
'Replacing the SmartClean System Cartridge').
C
10 When the entire cleaning cycle is complete
and the shaver is hygienically clean, the
ready symbol lights up continuously.
The battery symbol on the shaver will light up to
indicate the shaver is fully charged.
C
11 Press the top cap (1), pull the shaver
1
forward (2) and lift shaver from
SmartClean holder (3).
◗ The SmartClean System automatically turns
off 30 minutes after the cleaning and drying
phases are complete.
ENGLISH
29
6/26/14 3:15 P