Related Manuals for Beko HIC 95600 T1
Summary of Contents for Beko HIC 95600 T1
- Page 1 COOKTOP 88CM VITROCERAMIC HIC 95600 T1 User manual Page 1 Document Number : User Manual / 070820D...
- Page 2 Dear Customer, Your new Beko cooktop was manufactured in a state of the art facility and has passed the strictest quality control procedures. Please read this manual carefully before using your cooktop for the first time and then store it within easy reach for future reference. This manual will provide you with information on how to operate and care for your cooktop to gain the maximum benefit from it.
-
Page 3: Table Of Contents
Contents 1. General information 4. Preparation Technical Specifications Tips for energy saving Initial use 2. Safety Warnings First cleaning of the appliance General safety Electrical safety 5. Controls Product safety Switching on/off the cooktop Intended use Selecting a power level for Safety for children the heater Disposing of the old product... -
Page 4: General Information
Technical Specifications Model COOKTOP 88CM VITROCERAMIC Model number HIC95600T1 Material number 8101087000 Volts 220V –240V 50/60Hz~ Amperes 38.5 A Plate power rating (ø, mm/ W) Middle cooking zone 300mm 3 Stage Vitroceramic Plate 2700 W Front cooking zone left 165mm Vitroceramic Plate 1200 W Front cooking zone right 195mm Vitroceramic Plate 1800 W Rear cooking zone right... -
Page 5: Safety Warnings
Safety Warnings Model HIC95600T1 This section contains safety Ensure that the product instructions that will help you function knobs are switched off avoid risk of injury and damage. after every use. All warranties will become void if Electrical safety you do not follow these If the product has a failure, it instructions. -
Page 6: Product Safety
Care should be taken to avoid If the supply cord is damaged, it must be replaced by the touching heating elements. Children less than 8 years of manufacturer or its service age shall be kept away unless agent or a similarly qualified continuously supervised. -
Page 7: Intended Use
Do not spray aerosols in the This appliance is not intended vicinity of this appliance while to be operated by means of it is in operation. external timer or separate WARNING: If the surface is remote control system. cracked, switch off the Do not modify this appliance. -
Page 8: Safety For Children
This product has been Safety for children manufactured with high quality Accessible parts may become parts and materials which can hot during use. Young children be reused and are suitable for should be kept away. recycling. Do not dispose of the The packaging materials will waste product with normal be dangerous for children. -
Page 9: Installation
Installation The appliance must be installed by a The worktop must be aligned and fixed qualified person in accordance with horizontally. national regulations. Cut aperture for the cooktop in worktop as Installation is the buyer’s responsibility. per installation dimensions. The manufacturer accepts no liability for Cupboard design this service. - Page 10 DANGER Risk of electric shock, Risk of broken glass! short circuit or fire by damage Do not put the ceramic cooktop of the mains lead! down on a corner or edge. The mains lead must not be clamped, bent or trapped or come Electrical connection into contact with hot parts of the Connect the appliance to a grounded outlet/...
-
Page 11: Preparation
Preparation Initial use Tips for energy saving First cleaning of the appliance 1. Remove all packaging materials. The following information will help you to use your cooktop in an ecological way, and to The surface may get damaged save energy: by some detergents or cleaning materials. -
Page 12: Controls
Controls Basic functions Displays and LED’s The control allows different layout 5 7-segment displays [HEATERn_DISPLAY] configurations: n=1..5 to show the actual set on each heater, - Control for up to 5 Radiant heaters. show heater and cooktop special statuses KeyLock function. and show errors. -
Page 13: Switching On/Off The Cooktop
Switching On/Off the Cooktop. The Cooktop is switched ON by touching the [ON_OFF_KEY] key for 1 sec. A beep sounds and all the heater displays show a ‘0’. Switching ON the cooktop If the selection of a cook set for a heater is not done in 10 seconds, the Cooktop will be turned off automatically. -
Page 14: Selecting A Power Level For
Selecting a power level for a heater To switch on a heater it is necessary to actuate every cooking zone by means of two operations: Select a heater Select the desired cookset Selecting a heater A heater is selected by touching the heater [HEATER_n_KEY] key for 160 ms, a beep sounds and the heater display shows the power level. - Page 15 Selecting a power level for a heater Once the heater is selected, the power level can be selected by touching the [SLIDER]. Each position over the slider surface corresponds to a cooking level. The power level selection is done by sliding the finger or by placing the finger on a specific position of the slider surface.
-
Page 16: Selecting An Extension Zone For A Radiant Heater
Selecting an extension zone for a radiant heater To switch on a heater it is necessary to actuate every cooking zone by means of two operations: Select a heater Select the for enabling/disabling extensions the [DOUBLE_ZONE_KEY] key. Selecting a an extension zone Once the heater is selected, the extension zones can be enable/disable by touching the [DOUBLE_ZONE_KEY] key. -
Page 17: Key Lock
Key lock The key-lock is always activated at the start up of the control. The locking function can be activated every time if the Stop&Go function is OFF. Touching the [KEYLOCK_KEY] key for 1 second, the key lock function is activated or deactivated. -
Page 18: Residual Heat
Residual Heat Stop & Go function The Stop and Go function allows temporary Radiant Heaters Residual Heat pausing of the cooking process, allowing the Once cooking has finished, the user user to answer the door or the telephone interface indicates if there is remaining heat without having to be concerned about in the corresponding heater. - Page 19 Stop & Go Page 19...
- Page 20 The stop function will finish: if the [STOP_GO_KEY] is touched for more than 120 milliseconds a beep sounds and the heaters actual power setting is restored, or if the cooktop is stopped for more than 10 minutes the cooktop is switched off automatically.
-
Page 21: Operating The Timer
Operating the timer The timer value can be selected between 1 and 99 minutes. It is possible to set the time for any heater at any power level, including power level 0. The user can select only one heater at a time on which the timer function is to operate. -
Page 22: Selecting The Time
Selecting the time The timer display flashes whilst the timer is awaiting a time selection . The timer value can be selected between 1 and 99 minutes touching the [+TIMER] or [-TIMER] keys,. If the key [+TIMER] or [-TIMER] associated with the timer is held down, the change speed is increased automatically. - Page 23 Timer countdown end The timer alarm can be cancelled at any time, even during the first minute of the alarm. When the timer is in the alarm status, by pressing any key of the touch control the timer is switched off. Switching off the timer To cancel the operation of the timer, select the time value of “00”...
- Page 24 When selecting a heater power level and the If any heater is timed then the Minute Minute minder is running, the selected Minder cannot be selected. heater can not be temporised. Remember it is possible to set the time for any heater at power level 0.
-
Page 25: Errors/Alarms
Errors/Alarms Appliance errors Appliance errors are the errors which generate the deactivation of the whole cooktop. When an appliance error is detected, all heaters are switched off, a beep sounds (only if one or more heaters are active) and all displays show an ‘F’ letter and the error code alternately. - Page 26 Heater control errors Heater control errors are the errors which generate the switch off of one or more heaters. When a heater error is detected, the involved heaters are switched off, a beep sounds (only if one or more heaters are active) and the displays corresponding to these heaters show an ‘F’...
-
Page 27: Maintenance And Care
A pot with rough edges could scratch the which is available from all Beko Service Vitroceramic cooktop if it were dragged Centres. Remove calcium stains (yellow across the surface of the cooktop. - Page 28 Page 28...