Sealey 3200LEHL Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear safety
instructions footwear
1. SAFETY
Use jack only in accordance with this instruction manual.
9
Ensure the jack is in sound condition and good working order. Take action for immediate repair or replacement
9
of damaged parts. Use genuine parts only. DO NOT modify the jack.
The use of non-genuine parts may be dangerous and will invalidate the warranty.
Locate the jack in a suitable, well lit working area.
9
Keep working area clean and tidy and free from unrelated materials. Use jack on level and solid ground,
9
preferably concrete. Avoid tarmacadam as jack may sink in.
Chock wheels of vehicle.
9
Ensure the vehicle handbrake is engaged, engine is switched off and transmission is in gear (or "PARK" if
9
automatic).
9 Ensure minimum distance of 0.5m between vehicle and static objects such as doors, walls, etc. to allow for
vehicle tilting.
9 Ensure all non-essential persons keep a safe distance whilst the jack is in use.
Ensure there are no passengers in the vehicle.
9
The operator of the jack must watch the jack and the load during all movements.
9
Place jack under only those lifting points recommended by vehicle manufacturer (see vehicle handbook).
9
Check that the lifting point is stable and centred on the jack saddle.
9
Ensure the jack wheels are free to move and that there are no obstructions.
9
▲ DANGER: Use the jack for lifting only, NOT for supporting the lifted load.
Ensure there are no persons or obstructions beneath the vehicle before lowering.
9
Use suitable axle stands under the vehicle before proceeding with any task.
9
Use a qualified person to lubricate and maintain the jack.
9
Ensure that only hydraulic jack oil is used in the jack.
9
DO NOT operate the jack if damaged.
8
DO NOT allow untrained persons to operate the jack.
8
DO NOT operate the jack when tired or under the influence of drugs, alcohol or intoxicating medication.
8
DO NOT exceed the rated capacity of the jack.
8
DO NOT allow the vehicle to move during lifting or lowering, or use the jack to move the vehicle.
8
DO NOT jack vehicle if there is a risk of spillage of fuel, battery acid, or other dangerous substances.
8
DO NOT work under the vehicle until appropriately rated axle stands have been correctly positioned.
8
DO NOT use the jack for purposes other than that for which it is intended.
8
DO NOT top up hydraulic system with brake fluid. Use hydraulic jack oil only. (Sealey Part No: HJO500MLS or
8
HJO5LS)
DO NOT adjust the safety overload valve.
8
When not in use store jack, fully lowered, in a safe, dry, childproof area.
9
When lifting a load at the jack's max. rating, or close to it, it is recommended that the effort of raising the load shall be reduced by the
9
use of assistance during this operation.
2. INTRODUCTION
Three Trolley Jacks in one, the lifting span is quickly and easily adjusted, giving the advantages of a low entry, high lift and super
high lift in one Trolley Jack. Lifting range from a minimum saddle height of just 98mm for low chassis vehicles, to a maximum
saddle height of 770mm for extreme off-road vehicles. Reinforced lifting arm and solid u-channel side plates keeps all lifts strong
and secure. Rocket lift cast iron pump with twin pistons bring the lifting arm into contact with the jacking point in minimal pumps.
Long 2-piece handle, less effort for the operator. Supplied with foam bumper to protect bodywork. Rubber pads fitted to both
saddles to prevent damage to the underside of the vehicle's jacking point. Heavy-duty 360° castors and large saddle design for
easy positioning under the vehicle.
3. SPECIFICATION
Model No: ............................................................. 3200LEHL
Applicable Standards: ............................................... EN1494
Capacity ...........................Low Profile 2tonne/High lift 3tonne
Length ........................................................................ 805mm
© Jack Sealey Limited
2/3 TONNE LOW PROFILE/HIGH LIFT
TROLLEY JACK WITH ROCKET LIFT
3200LEHL
MODEL NO:
Maximum chassis height ............................................ 153mm
Minimum saddle height ................................................ 98mm
Maximum saddle height ............................................. 770mm
Original Language Version
TJL3
1 3 5
2 4 R
Use on h rd level floor
Chock
wheels
Close
Lower
Lift & twist
to lower
Use suit ble xle st nds
X2
w w w . s e l e y. c o . u k
3200LEHL Issue 2 (2) 28/04/23
Apply
h ndbr ke
Never
exceed
j ck c p city
R ise
OR
R ise