Table of Contents
Advertisement
STEP 1: (SEE FIGURE 9)
•
Assemble one angle support bracket to the topmost
set of holes in the hanger brackets using two 3/8" x
1" hex bolts (D) and 3/8" nylock nuts (M). Assemble
the second angle support bracket to the second from
the bottom set of holes in the hanger brackets using
two 3/8" x 1" hex bolts (D) and 3/8" nylock nuts (M).
Be sure the brackets are turned as shown. Do not
tighten yet.
3/8" x 1"
HEX BOLT (D)
3/8" NYLOCK
NUT (M)
FIGURE 9
STEP 1: (SEE FIGURE 11)
•
Attach an angle support bracket to the top holes in
the quick attach brackets using two 3/8" x 1" hex bolts
(D) and 3/8" nylock nuts (M). Do not tighten
•
Attach an angle support bracket to the bottom holes
in the quick attach brackets using two /8" x 1" hex
bolts (D) and 3/8" nylock nuts (M). Do not tighten.
3/8" x 1"
HEX BOLT (D)
BEND
FACES
IN
FIGURE 11
INSTRUCTIONS FOR 917 MODEL TRACTORS
ANGLE SUPPORT
BRACKET
INSTRUCTIONS FOR 247 MODEL TRACTORS
BEND
FACES
OUT
3/8" NYLOCK
NUT (M)
STEP 2: (SEE FIGURE 10)
•
Assemble the pivot support bracket to the angle
support brackets using four 3/8" x 1" hex bolts (D)
and four 3/8" nylock nuts (M). Do not tighten yet.
•
Tighten the 4 bolts fastening the angle support
brackets to the hanger brackets.
•
Tighten the 4 bolts fastening the pivot support
bracket to the angle support brackets.
•
GO TO PAGE 10.
3/8" x 1"
HEX BOLT (D)
FIGURE 10
STEP 2: (SEE FIGURE 12)
•
Assemble the pivot support bracket to the slotted
angle support brackets using four 3/8" x 1" hex bolts
(D) and four 3/8" nylock nuts (M). Do not tighten yet.
•
Tighten the 4 bolts fastening the slotted angle
support brackets to the quick attach brackets.
•
Tighten the 4 bolts fastening the pivot support
bracket to the slotted angle support brackets.
•
GO TO PAGE 9.
3/8" x 1"
HEX BOLT (D)
3/8" NYLOCK
NUT (M)
FIGURE 12
8
3/8" NYLOCK
NUT (M)
PIVOT SUPPORT
BRACKET
PIVOT SUPPORT
BRACKET
Advertisement
Table of Contents
