Dell OptiPlex 5080 Small Form Factor Service Manual page 35

Steps
1. Align the pin-1 corner of the processor with the pin 1 corner of the processor socket, and then place the processor in the processor
socket.
NOTE: The pin-1 corner of the processor has a triangle that aligns with the triangle on the pin-1 corner on the
processor socket. When the processor is properly seated, all four corners are aligned at the same height. If one or
more corners of the processor are higher than the others, the processor is not seated properly.
2. When the processor is fully seated in the socket, close the processor cover.
3. Press down and push the release lever under the tab to lock it.
Next steps
1. Install the heat-sink.
2. Install the front bezel.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Field service information 35