Philips S95 Series Manual page 17

Charging with the supply unit
1 Make sure the appliance is switched off.
2 Put the supply unit in the wall socket and put the small plug in the
appliance (Fig. 15).
3 After charging, remove the supply unit from the wall socket and
pull the small plug out of the appliance.
Charging in the SmartClean system
(specific types only)
1 Put the small plug in the back of the SmartClean system.
2 Put the supply unit in the wall socket.
3 Press the top cap to be able to place the shaver in the holder
(‚click') (Fig. 16).
4 Hold the shaver upside down above the holder. Make sure the
front of the shaver points towards the SmartClean system (Fig. 17).
5 Place the shaver in the holder (1), tilt the shaver backwards (2) and
press down the top cap to connect the shaver ('click') (3) (Fig. 18).
Note: The battery symbol starts to flash to indicate that the appliance
is charging. When the battery is fully charged, the battery symbol
lights up continuously.
Using the appliance
Note: This appliance can only be used without cord.
Switching the appliance on and off
-
To switch on the appliance, press the on/off button once (Fig. 19).
The display lights up for a few seconds.
-
To switch off the appliance, press the on/off button once.
The display lights up for a few seconds and shows the remaining
battery charge.
17
English