Sealey VSE725.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to instruction
manual
1. SAFETY
 WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using tools.
 Maintain the tool components in good and clean condition for best and safest performance.
 Ensure that a vehicle which has been jacked up is adequately supported with axle stands.
 Wear approved eye protection. A full range of personal safety equipment is available from your Sealey stockist.
 Wear suitable clothing to avoid snagging. DO NOT wear jewellery and tie back long hair.
 Keep children and other unauthorised persons away from the working area.
 Ensure there is adequate lighting prior to using the ball joint replacement tool.
 DO NOT use the kit if any parts are missing or damaged.
 DO NOT use the ball joint replacement tool for any purpose other than that for which it is designed.
IMPORTANT: These instructions are intended as a guide only. Always refer to the vehicle manufacturer's service instructions or a proprietary
manual to establish the current procedure.
2. INTRODUCTION
Suitable for removing and installing the upper front ball joint on-vehicle
without the need to disassemble. Features a variety of adaptors used in
different combinations for extracting and installing, see below. Supplied in
a carry-case with each part numbered for simple selection.
3. APPLICATIONS
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .VSE725.V2
Applications: . . . . . . . . . . . . . . . . . . . . . . VW: T4 2000cc, T4 2500cc
5. OPERATION
© Jack Sealey Limited
INSTRUCTIONS FOR:
FRONT AXLE UPPER BALL JOINT
EXTRACTOR/INSTALLER - VW T4
VSE725.V2
MODEL NO:
Wear eye
protection
Clean and lubricate the thrust screw with grease before use
Original Language Version
4. CONTENTS
VS725.V2 Issue: 1 21/07/16