Sealey PS985.V2 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
WARNING! Ensure all Health and Safety, local authority, and general workshop practice regulations are strictly adhered to
‰
when using tools.
DO NOT use tools if damaged or worn.
8
Maintain the tools in good and clean condition for best and safest performance.
9
Ensure all threads are clean and well lubricated.
9
Always check that puller is correctly assembled and is square with the workpiece.
9
If vehicle is raised, ensure it is adequately supported with axle stands, ramps, etc. as appropriate.
9
Wear suitable clothing to avoid snagging. DO NOT wear jewellery. Tie back long hair.
9
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.
9
Where possible shield workpiece with canvas or similar to provide protection against failed parts.
9
DO NOT heat puller jaws when heating a gear or bearing as this will affect the temper and, therefore, the strength of the material.
8
DO NOT use any tool or lever to turn the ram tommy bar, use hand effort only.
8
DO NOT hit workpiece, or ram, with a hammer if workpiece has not moved with maximum puller force applied. Use a larger capacity puller.
8
Account for all tools and parts being used and DO NOT leave them in or on the vehicle.
9
IMPORTANT: Always refer to the vehicle manufacturer's service instructions, or proprietary manual, to establish the correct
procedure and data. These instructions for use are provided as a guide only.
2. INTRODUCTION
Cast puller yoke with forged separator. 10tonne Hydraulic ram interchangeable with other units in the series. Supplied with Ø75-105mm
(PS980) or Ø105-200mm (PS985) bearing separator. Maximum puller depth 420mm. Supplied in steel case.
3. CONTENTS
Model PS980.V2 (fig.1)
Item Part No. Description
1 PS988 Bearing Seperator Ø75 to 105mm
2 PS990 Hydraulic Ram 10tonne
3 PS982/9014 Beam
4 PS982/9016 Rod, main (pair)(male/male)
5 PS982/8013 Centre Adaptor
© Jack Sealey Limited
HYDRAULIC BEARING SEPARATOR/PULLER
SET
MODEL NOS:
Wear protective Wear safety
gloves footwear
Original Language Version
PS980.V2, PS985.V2
Wear protective
clothing
fig.1
4
PS980.V2, PS985.V2
2
3
5
1
Issue 2 (H,3,F) 02/02/22