Sealey PS983.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protec-
instruction manual tive gloves
1. SAFETY
WARNING! Ensure all Health and Safety, local authority, and general workshop practice regulations are strictly adhered to when using
‰
tools.
DO NOT use tools if damaged or worn.
8
Maintain the tools in good and clean condition for best and safest performance.
9
Ensure all threads are clean and well lubricated.
9
Always check that puller is correctly assembled and is square with the workpiece.
9
Ensure the nuts and bolts are tight on the jaw heads.
9
If vehicle is raised, ensure it is adequately supported with axle stands, ramps, etc. as appropriate.
9
Wear suitable clothing to avoid snagging. DO NOT wear jewellery. Tie back long hair.
9
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.
9
Where possible shield workpiece with canvas or similar to provide protection against failed parts.
9
DO NOT heat puller jaws when heating a gear or bearing as this will affect the temper and, therefore, the strength of the material.
8
DO NOT hit workpiece with a hammer if workpiece has not moved with maximum puller force applied. Use a larger capacity puller.
8
Account for all tools and parts being used and do not leave them in or on the vehicle.
9
IMPORTANT: Always refer to the vehicle manufacturers service instructions, or proprietary manual, to establish the correct procedure and
data.
NOTE: This tool will exert strong forces on the object being worked on and may damage some objects depending on force required.
2. INTRODUCTION
i
2.3kg Slide hammer with 580mm shaft. Use eight ways: external 3-leg puller, internal 3-leg puller, external 2-leg puller, internal 2-leg
puller, grip wrench adaptor, lip puller, hub puller, dent puller. Supplied in storage case.
3. SPECIFICATION
i
Model No: PS983. V2
Twin leg:
Internal Capacity:
Reach:
External Capacity:
Reach:
Triple Leg:
Internal Capacity:
Reach:
External Capacity:
Reach:
© Jack Sealey Limited
INSTRUCTIONS FOR
SLIDE HAMMER/PULLER SET 10PC
MODEL NO:
Wear eye
protection
Ø35-110mm
83mm
Ø35-110mm
83mm
Ø30-110mm
83mm
Ø30-110mm
83mm
Original Language Version
PS983.V2
Wear ear
protection
PS983.V2 Issue 2 (3) 25/09/23