Bosch NGM8656UC Use And Care Manual page 16

Burner Base and Burner Cap Placement
After electrical connection is complete, place each
▯
burner base on the corresponding location on the
cooktop.
Pay special attention to avoid damaging the igniter
▯
during installation of the base.
The small hole or cutout near the edge should also
▯
line up with the igniter.
Once each burner base is located and resting evenly,
▯
place each burner cap on its correct burner base.
Place burner cap gently on top of base so that the
▯
prongs of the burner base fit snugly into the groove of
the burner cap.
Make sure the cap is centered on the burner base and
▯
lies flat and that there is no gap between the burner
base and the burner cap.
Gently try to move the burner cap from side to side to
▯
check for proper placement. If placement is correct,
the cap will click from side to side as the prongs hit
the grooved ridge on the underside of the cap.
If the maintop is removed by a certified installer (for
▯
example to check electrical or piping connection) the
panhead screws that were removed must be re-
installed to ensure proper functionality of burners.
16