Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. – No parts required Prepare the machine. Upper mount Main bracket Top bracket Lower support bracket Welded support bracket Carriage bolt (5/16 x 7/8 inch) Install the kit.
Assembling the Kit Assemble the kit as shown in Figure 2. Ensure to loosely install the upper mount to the main bracket; refer to Figure 3 to determine which hole to use in the upper mount. Note: Install the lower support bracket only if you are mounting the kit in front of the rear tires. Install the bracket so that the large face is oriented rearward on the machine;...
g037081 Figure 3 1. Use this hole if you are mounting the kit in front of the left, 3. Use this hole if you are mounting the kit in front of the right, rear tire. rear tire. 2. Use this hole if you are mounting the kit in any location behind the rear tires.
Page 5
Mounting the Kit in Front of the Rear Tires 1. Secure the mount assembly to the console cover using 2 bolts (5/16 x 1 inch) and 2 nuts (5/16 inch) as shown in Figure 5 Figure 2. Tighten the fasteners securing the upper mount to the main bracket. 3.
Page 6
Mounting the Kit to the Side of the Engine Guard 1. Secure the mount assembly to the side upper guard using 2 bolts (5/16 x 1 inch) and 2 nuts (5/16 inch) as shown in Figure 7 Figure 2. Tighten the fasteners securing the upper mount to the main bracket. 3.
Page 7
Mounting the Kit to the Rear Engine Guard 1. Secure the mount assembly to the rear upper guard using 2 bolts (5/16 x 1 inch) and 2 nuts (5/16 inch) as shown in Figure 9 Figure 2. Tighten the fasteners securing the upper mount to the main bracket. 3.
1. Add a front-weight kit when 2 or more accessory-mount kits are installed at these positions. Operation Mounting Attachments Use only Toro-approved attachments and accessories. The maximum capacity is 11.3 kg (25 lb). Use the holes in the mounting brackets to secure attachments or accessories.