Table of Contents
Advertisement
AUTODOME IP 5000 IR
8
Connection
Warning!
Bosch's version of PoE+
!
If supplying power to the camera by PoE+ or by a midspan device, you must install additional
surge protection.
Warning!
Bosch's version of High PoE:
!
If supplying power to the camera by HPoE or a midspan device, you must install additional
surge protection.
Caution!
Compliance with EN50130-4 Alarm Standard – CCTV for Security Applications
To meet the requirements of the EN50130-4 Alarm Standard, an ancillary uninterruptable
!
power (UPS) supply is necessary. The UPS must have a Transfer Time between 2–6 ms and a
Backup Runtime of greater than 5 seconds for the power level as specified on the product
datasheet.
Note: Consult the National Electrical Code (NEC) for cable bundling requirements and
limitations.
4
Label ID
AC24V
AC24V
EARTH
4
Bosch Security Systems
Connect the cable to the 24 VAC wires from the camera.
Description
24 VAC
24 VAC
Earth Ground
Connect the Ethernet cable to the RJ45 connector of the camera. The following figure
illustrates a typical system configuration.
Cable Wire Color
Red
Black
Yellow/Green
Installation Manual
Connection | en
21
2015.05 | 0.3 |
Advertisement
Table of Contents
