Bosch Nexxt DLX Series Operating, Care And Installation Instructions Manual page 23

Fault
Water cannot be seen in
drum.
Indicator light rinse" is lit
and display is flashing
E:04" with no water re
maining in tub.
Water is flowing out from g
underneath the machine.
Suds coming out of the
detergent dispenser. g p
Repeated spinning.
The laundry was not
spun.
Program duration ex
tended.
Unsatisfactory washing
result.
Detergent residue on the
laundry.
Gray residue on the laun
dry.
System shakes or shudders
when passing from lower to
higher speed spinning.
If the fault cannot be eliminated with the aid of the above table, switch the appliance off, wait 5 seconds, switch the appliance on
again, select and start the program.
If the fault continues, call customer service; see Page 24.
All manuals and user guides at all-guides.com
Possible cause
This is not a fault.
The water level is below the visible part of the drum.
Suds or pump is blocked.
he thread of the supply hose is not tight.
T
Leak in the drain hose.
Too much soap or non-HE soap used, pump could
not remove suds.
This is not a fault.
The imbalance compensation system is attempting to
balance the load through repeated spins.
Large items of clothing have become entangled and
could not be distributed evenly in the drum. For safe
ty reasons the high speed spin cycle was automati
cally suppressed.
This is not a fault.
The suds detection feature has activated an addi
tional rinsing cycle to reduce the amount of suds.
This is not a fault.
The imbalance compensation system is attempting to
balance the load through repeated spins.
The degree of soiling was higher than estimated.
Not enough detergent.
Some phosphate free detergents contain water insol
uble residues that may appear as light spots on the
laundry.
Dirt accumulation from ointments, fats or oils.
Drum system suspension can shift during speed up, this
is not a failure.
Action
Use less detergent for future wash loads. Detergents
specifically designed for your High Efficientcy washer
produce fewer suds and will include the letters HE"
on the packaging. Clean the water drainage pipe
and/or drain hose. Turn the program selector to off"
and restart Drain program.
Tighten the thread.
Replace the drain hose.
Mix 1 tablespoon of fabric softener with 1 pt (½ litre)
of water and pour into detergent dispenser III.
Use less detergent for future wash loads. Detergents
specifically designed for you High Efficientcy washer
produce fewer suds and will include the letters HE"
on the packaging.
Always load the drum with large and small items
together.
Always load the drum with large and small items
together.
Add a more appropriate amount of detergent.
Always load the drum with large and small items
together.
Select suitable program
or
Heavy duty as an additional option.
Add detergent according to the manufacturer's
specifications.
Brush off spots when laundry is dry.
Add the maximum amount of detergent and select
the highest permissible temperature.
Mix small and large laundry pieces in load to minimize
this effect.
23