Beko ATP 7100 I Instruction Manual page 11

To Operate Your A P
7
1. Connect the appliance with power source,
2. Touch the Power button once,
be heard, the appliance starts to run under
under the default "AUTO" setting, its corre-
sponding indicator will
quality indicator will
red according to the actual air quality.
- Very good air quality: The air quality indi-
cat ates in blue.
- Good air quality: The air quality indicator
ates in pink.
- Bad air quality: The air purifier
in red.
3. And you can select your required speed set-
ting by following the operation described in
"CONTROLS INTRODUCTION". After select,
ower
utton
Air purifier/ Instruction Manual
rd.
ate, and the air
ate in blue, pink or
the corresponding indicator of selected speed
setting will turn on.
can 4. After turn on the air purifier and select your
required speed setting, you can activate the
by following the operation as below:
Touch down Timer button on the control
panel, one beep
3 settings including 2H, 4H and 8H for selec-
tion. After select your required
indicator of selected
When the
power off aut
select
ates
5. When the filter change indicator
nates in white, it is
filter. Please change the HEPA filter by follow-
ing the operation described in the section of
"CHANGE THE HEPA FILTER".
Filter change
indicator
can be heard. There are
will
expires, the air purifier will
atically and the indicator of
extinguish.
to change the HEPA
the
ate.
-
11 / EN