Advertisement
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
9
HOSE
(See Figures 9A and 9B)
1. Place both clamps over the hose.
2. Slide the hose over the inlet at the top end.
3. Slide the hose over the lower chute inlet.
4. Remove any twists in the hose by rotating it
at the top or bottom end.
5. Tighten the clamps.
COVER
FIGURE 9A
FIGURE 9B
www.mymowerparts.com
ASSEMBLY
10
BLADE REPLACEMENT
Tools Needed:
9/16" Socket and Ratchet
Ft/Lbs Torque Wrench
The mower comes from the factory with a low lift
blade. The blades need to be replaced with the
high lift blades provided in kit. Failure to do this
may result in poor performance of the collection
system.
1. Lift up the front of the mower and secure with
jack stands.
HOSE
2. Using a 9/16" socket and ratchet, remove the
blade bolts and blades.
3. Reinstall the new high lift blades and bolts.
LOWER
CHUTE
4. Torque the blade bolts to 35 ft/lbs.
11
LEVEL MOWER DECK
Be sure deck is properly leveled for best mower
performance. See your mower operator's manual
for instructions.
11
Advertisement
