Table of Contents
Advertisement
To do a check of the right hand guard
•
Make sure that the right hand guard is not damaged
and that there are no defects, such as cracks.
To do a check of the vibration damping
system
1. Make sure that there are no cracks or deformation
on the vibration damping units.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
Product overview on page 2 for information
Refer to
about where the vibration damping system is on your
product.
To do a check of the start/stop switch
1. Start the engine.
2. Push the start/stop switch to the STOP position. The
engine must stop.
To do a check of the muffler
WARNING:
arrester and spark arrester mounting face
may contain deposits of combustion
particles on the surfaces that may be
carcinogenic. To avoid skin contact and
inhalation of such particles when cleaning
and/or servicing the spark arrester, make
sure you always:
•
wear gloves;
•
clean and/or service in a well ventilated
area;
•
do not use pressurized air to clean the
spark arrester screen;
•
use a steel brush and brush away from
your body when cleaning the spark
arrester.
24
A used muffler/spark
WARNING:
has a defective muffler or a muffler that is in
bad condition.
WARNING:
spark arrester mesh on the muffler is
missing or defective.
1. Examine the muffler for damages and defects.
2. Make sure that the muffler is correctly attached to
the product.
3. If your product has a special spark arrester mesh,
clean the spark arrester mesh weekly.
4. Replace a damaged spark arrester mesh.
CAUTION:
blocked the product becomes too hot and
this causes damage to the cylinder and
piston.
Carburetor adjustment
Because of environmental and emissions laws, your
product has adjustment limitations on the carburetor
adjuster screws. This decreases the harmful exhaust
Do not use a product that
Do not use a product if the
If the spark arrester mesh is
591 - 003 - 23.02.2021
Advertisement
Table of Contents
