Table of Contents
Advertisement
Troubleshooting
q Operation
p
Symptom
No power
Cannot operate
( common to
wireless remote
controller, HD Visual
Communication Unit)
Cannot perform
operations with the
remote controller
using the IR repeater
function
Camera is out of
alignment with the
preset positions
The status display
lamp has lighted up
in red
Cause and remedial action
p p Is the power plug securely connected to the AC outlet?
p p Are the AC adapter and the power cable connected properly?
p p Is the power on?
If the unit's status display lamp is off, it means that the unit's
power is not being supplied.
p p Has the camera been selected correctly from the HD Visual
Communication Unit?
p p Have the remote control's batteries run down or have the
batteries been installed with their polarities reversed?
If the status display lamp does not blink even when the remote
controller is operated near the remote controller signal receiver, it
means that the batteries have run down. Replace the batteries.
p p Is there a fluorescent light or plasma monitor near the unit and,
if so, is the remote controller signal receiver exposed to its
light?
p p Are the signals of the remote controller being received by the
HD Visual Communication Unit?
p p Has the IR system/service selector switch been set to the
service position?
p p The camera may not be in alignment with the preset position
if its position was forcibly moved by hand while images were
being displayed.
Turn the camera's power off and then back on.
p p Trouble has occurred in the camera.
Turn the camera's power off and then back on.
Reference pages
–––
P.15
P.17
Operating instructions
of the HD Visual
Communication Unit
Operating instructions
of the HD Visual
Communication Unit
–––
P.16
P.13
P.17
P.13
P.17
19
Advertisement
Table of Contents
